SDI Technologies INC ISP5WW4TC User guide

  • Hello! I am an AI chatbot trained to assist you with the SDI Technologies INC ISP5WW4TC User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Button
• Press once to manually control the switch (Turning plug “On” or “Off”)
• Press and hold for 10 seconds to reset the software
(LED will flash red and green and SmartPlug will reset upon release.
Use app to reconfigure network settings)
Wi-Fi Status Indicator
Flashing Green: SmartPlug is searching for a Wi-Fi network
Solid Green: SmartPlug is connected to a Wi-Fi network
Flashing Red: SmartPlug is disconnected from a Wi-Fi network
Power On/Off Status Indicator
• Lights up when SmartPlug is “On” and electricity is flowing through
• Power indicator will blink once when firmware is successfully installed
Electrical Ratings
120V Volts AC, 60Hz
15A
1800W
Safety Warnings
• Plug directly into electric outlet (not into extension cord)
• For indoor use only
• Remove Smartplug from outlet before cleaning
• DO NOT clean with liquid
• DO NOT remove ground pin (middle pin)
• DO NOT use in wet or damp areas
• Keep children away from SmartPlug and outlet
DO NOT exceed the recommended electrical ratings
• DO NOT use in precision timing applications where inaccurate timing could
be dangerous (sunlamps, saunas, etc.)
• DO NOT use with devices that should not be operated unattended
Recommendations
• Test device locally for safe operation before attempting to control it remotely
• DO NOT use with an oulet controlled by a wall switch as the switch may be off
PLUG OVERVIEW:
Button
Wi-Fi Status Indicator
Power Indicator
SMARTPLUG
QUICK START GUIDE
1. Make sure your mobile device is connected to your preferred
Wi-Fi network.
2. Download and open the free iHome Control app from the
App Store or Google Play.
(Apple: iOS 8.1 or later; Android: Jelly Bean 4.2 or later)
3. Log in or Sign Up for an iHome account.
4. Plug the SmartPlug into a desired outlet. The Green LED will
start blinking to indicate it is ready for setup.
5. Tap ‘’Search for Devices” and follow the on-screen directions
to complete setup.
6. When prompted, enter the Accessory Setup Code below to
complete setup.
Note: To add more plugs (or repeat the plug setup process),
tap the “Devices” icon and then tap “Add Device.”
7. For troubleshooting visit www.iHome.com/support/smartplug
iSP5
PIN LABEL
/