2. Poewit
  3. WAP-2O
WAP-2O

Poewit WAP-2O User guide

  • Hello! I've reviewed the Quick Start Guide for the PoEWit WAP-2O Cloud-Intelligent Outdoor Wi-Fi 6 Wireless Access Point. This guide provides instructions on how to install and set up the device, including connecting it to an existing or new network. It also covers the default SSIDs and passwords. I'm ready to answer any questions you have about the WAP-2O.
  • What does a blue LAN1 LED indicate?
    What does an amber LAN1 LED indicate?
    What are the default SSIDs for the WAP-2O?
    What are the default passwords for the WAP-2O?
poewit.com
CLOUD-INTELLIGENT
Enterprise-Class | Ultra-High-Density
OUTDOOR
WI-FI 6 WIRELESS
ACCESS POINT
QUICK START GUIDE
WAP-2O
poewit.com
INSTALLATION AND SETUP
1
1) After mounting the WAP-2O, connect an Ethernet cable (Cat5/6)
from the LAN1 port to the Router.
• Note: A blue LAN1 LED indicates a link of 2.5Gbps. An amber
LED indicates a link of 100/1000Mbps.
• Note: The WAP-2O and the mobile device running the PoEWit ..
App must be on the same external IP address and the same ....
local subnet.
3) Once powered On, the WAP-2O will automatically connect to the
internet, and the Power LED will appear blue when the device is
ready for operation.
4) There are two installation scenarios depending on whether or not
there is a wireless network already installed.
4a) With an Existing AP on the Network:
1. Connect to the existing AP using your mobile device.
poewit.com
INSTALLATION AND SETUP
2
2. Open the PoEWit App to discover and configure the new
WAP-2O.
4b) With No Existing AP on the Network:
1. Connect to the newly-installed WAP-2O using the default
SSID and Passcode.
poewit.com
INSTALLATION AND SETUP
3
Default SSID and Passcode:
1. Connect to the newly-installed WAP-2O using the default
SSID and Passcode.
Default SSID and Passcode:
2. Open the PoEWit App to discover and configure the new
WAP-2O.
3. Once the settings are saved, the WAP-2O will reboot and
lose connection to the mobile device. Allow 30 to 60
seconds for the WAP-2O to reestablish power.
4. Once power is restored, connect to the new SSID you setup.
SSID
poewit_2.4G_1
poewit_5.0G_1
poewitguest_2.4G
poewitguest_5.0G
Passcode
3301Andrews
3301Andrews
WelcomeGuest
WelcomeGuest
poewit.com
INSTALLATION AND SETUP
4
/