Assa Abloy Lockwood Cavity Lock Installation guide

Brand: Assa Abloy

Model: Lockwood Cavity Lock

Type: Installation guide

Drill Ø2mm pilot hole squarely

through the door.

CAVITY LOCK

Sliding Door Furniture

Backset 60mm

Fold here on door edge

mplate

Door and pull preparation template

Passage Set door preparation and pull installation (steps 1 - 9)

Fold here on door edge

1300 LOCK UP

lockweb.com.au

Please ensure that all necessary safety precautions are taken when installing this product.

Q50048 C 0516

Chisel out recess to suit face

plate. Face plate must be flush

with door face.

Insert pull into recess.

Mark and drill 2mm pilot holes,

and ax with screws provided.

Press the retractable door pull

button to release it.

(Press it to reset).

Pull on the retractable door pull

to remove door from cavity.

Insert pull into Ø25mm hole,

mark around latch face plate.

1. Drill Ø25mm pull hole to depth

of 70mm, ensure hole is

drilled squarely.

2. Drill a Ø54 furniture hole,

from both sides of door to

prevent splintering.

1. Find centre of door edge

and mark ready for drilling

Ø25mm pull hole.

2. Mark hole position ready for

drilling Ø54 furniture hole,

both sides of door.

Mark line on the door face

approximately 900mm from

the floor. Tear along perforated

line on template. Fold page

along --- dashed line and place

fold on door edge. Align CL with

marked line on door face.

Important Note

Drill hole from both sides of door

to prevent splintering of the door face.

Mark hole

position ready

for drilling

Ø54mm

furniture hole.

Find centre of

door edge and

mark ready for drilling

Ø25mm latch hole.

Tear along perforated edge

Tools Required

- Ø54mm Hole saw

- Ø25mm Spade bit

- Ø2mm Drill bit

- Power drill

- 25mm Chisel

- Pencil

- Ruler or tape measure

- Phillips head screw driver

32MM - 45MM

DOOR THICKNESS

INSTALLATION OF

PASSAGE SET

Status Approved 2016-05-16

CAVITY LOCK

Sliding Door Furniture

32MM - 45MM

DOOR THICKNESS

INSTALLATION OF

PASSAGE SET

Slide door using finger grip.

Mark around strike plate.

Drill 2mm pilot holes.

Affix with screws provided.

Passage set installation (steps 10 - 15)

Passage set strike installation (steps 16 - 21)

Screw sizes for Door Thickness:

32mm-40mm Use 25mm Screw

40mm-45mm Use 35mm Screw

Trilobe screw (Thread forming

screw)

Furniture assembly.

Assembly shows both sides

interlocking.

Assemble as shown with screw

holes vertical.

If door is less than 33mm thick

use packers. Fit the packers to the

inner faces of the furniture,

against the door face.

Mark a horizontal line on the door

(this line passes through the

centre of the 54mm hole).

Extend this line along the face

of the door jamb.

Align the pip on strike plate with

the line on the jamb (horizontal)

Align the pip on the strike plate

with the centre of the pull button

(vertical).

Chisel out recess for strike plate.

Strike plate must be flush with

door jamb.

Status Approved 2016-05-16

Assa Abloy Lockwood Cavity Lock Installation guide

Assa Abloy Lockwood Cavity Lock Installation guide

Assa Abloy Lockwood Cavity Lock Installation guide

Related papers

Other documents