THANK YOU
We appreciate the trust and condence you have placed in Deant through the purchase of
this alarm. We strive to continually create quality products designed to enhance your home.
Visit us online to see our full line of products available for your home improvement needs.
Thank you for choosing Deant!
USE AND CARE GUIDE
Pressure Activated Door Stop Alarm
Safety Information
Save these instructions for future use.
WARNING: Risk of personal injury. Prolonged exposure to the alarm siren may cause
permanent hearing loss.
WARNING: For indoor use only. Do not use in wet locations.
WARNING: Any battery may leak harmful chemicals which may damage skin, clothing or
the inside of the alarm.
TO AVOID RISK OF INJURY, DO NOT LET ANY MATERIAL LEAKED FROM A BATTERY COME IN
CONTACT WITH EYES OR SKIN. Any battery may rupture or explode if put in a re or otherwise
exposed to excessive heat.
TO AVOID RISK OF INJURY, DO NOT EXPOSE BATTERIES TO EXCESSIVE HEAT.
To reduce the risk of personal injury or harm to your alarm, take the following precautions:
□ Do not use different brands of batteries in the same alarm.
□ When replacing batteries always replace the whole set.
□ Do not use rechargeable or reusable batteries.
□ Do not allow children to install batteries unsupervised.
□ Follow battery manufacturer’s instructions as to proper handling, storage and disposal
of batteries.
LIMITATIONS OF ALARM PRODUCTS
WARNING: Test product regularly to ensure it functions in accordance with these
instructions. The manufacturer does not provide insurance or any guarantee that the risk of
burglary or robbery will be reduced or prevented even if this product is used properly. Obtain
proper insurance coverage for these risks. The manufacturer does not represent or warrant
that that this product may not be compromised or circumvented, that it will provide proper
or adequate warning, or that the use of this product will prevent injury, property damage or
other losses. Note that this product may be bypassed, compromised, fail or fail to warn like
any alarm, including due to improper installation, positioning, or maintenance; tampering;
dead, faulty, or improperly installed batteries; sensing limitations and component failures.
The product’s functional range may be affected or limited by environmental conditions, radio
frequency interference or other obstructions. Audible alarm signals may be outside of hearing
range, muted by doors, walls, and oors, unheard by deep sleepers or the hearing-impaired, or
overwhelmed by other sounds.
Pre-Installation
PRODUCT DESCRIPTION
1
3
Part Description
1 Battery Compartment
2 On/Off Switch
3 Low Battery Indicator
4 Metal Contact Plate (Cover)
Installation
1
Installing the battery
This alarm requires one 9V battery. When the low battery indicator (3) illuminates,
replace the battery:
Toggle the On/Off Switch (2) to the Off position to prevent unintentional triggering.
Remove the screw on the battery compartment cover (1).
Place a 9V battery into the connecting leaf and ensure the proper polarities.
Replace the battery cover (1).
2
Testing the alarm
Toggle the On/Off switch (2) to On.
Quickly but rmly tap down and release the metal contact plate (4). A quick siren
chirp indicates proper operation. Use the palm of your hand to cover the alarm to
reduce risk of hearing damage.
Toggle the On/Off switch (2) to Off.
Item # 1001 636 749
Model # THD-DS
Warranty
1 YEAR LIMITED WARRANTY
This product is guaranteed to be free of defects in materials and workmanship for 1 year
from the date of purchase. If this product is defective, call 844-212-0200 for repair or
replacement parts or return the product to the store from which it was purchased.
Guarantee does not include normal wear and tear, bulbs or batteries.
Contact the Customer Service Team at www.HOMEDEPOT.com.
3
Installing the alarm
Insert the wedge portion of the alarm at the base of the door as shown, with the
pointed edge under the door gap. The alarm is properly installed if the alarm
sounds and the metal contact plate (4) is pressed when the door is opened.
Make sure the non-skid pads on the bottom of the alarm are in rm contact with
the oor.
Operation
1. Toggle the On/Off switch (2) to On to activate the alarm.
2. Toggle the On/Off switch (2) to Off to deactivate the alarm.
2
Questions, problems, missing parts? Before returning to the store,
call Deant Customer Service
8 a.m. - 7 p.m., EST, Monday - Friday, 9 a.m. - 6 p.m., EST, Saturday
1-866-308-3976
HOMEDEPOT.COM