2. AMG
  3. AMG2266

AMG AMG2266 Instruction Sheet

  • Hello! I've reviewed the Instruction Sheet for the AMG2266 Video Transceiver. This document details the setup and specifications of the device, including video, optical, and data connections. It also outlines the pinouts and power requirements. I'm ready to assist you with any specific questions you may have about this device.
  • What type of video connector does this device use?
    What is the nominal input level for the video signal?
    What type of connectors are used for the optical connection?
    What is the wavelength of the optical signal?
    What kind of connector is used for data connection?
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D035113-02
AMG2266
Instruction Sheet
AMG2266 Standalone Video Transmit + Bi-directional FTT10A Data
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 6MHz min.
Optical Connection
Connectors............................ST Style (2 off)
Opto Out Launch Power
50/125............................-20dBm. min.
62.5/125.........................-17dBm min.
Wavelength...........................850nm nominal.
Data Connection
Connector .............................Push-in connector strip - 14way
(Solid conductors 0.5mm2(20 awg) can be connected by simply push fitting
into the appropriate connection hole. Smaller conductors and wires (up to
0.5mm2, 20 awg) are inserted into the connection space whilst depressing the
orange lever. Wire or conductors should be stripped back to a length of
11mm. Use a small screwdriver to depress the orange lever to release the
connection.)
VIDEO INPUT Opto OUT
(Single Fibre not fitted
Opto IN
(IN/OUT Single Fibre)
SYSTEM 2000
VIDEO
TRANSCEIVER
134mm
148mm
7mm
39.5mm
79mm A A
PL1
PIN 1
PIN 14
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D035113-02
Pinout ...................................See Below – Note Pins number from the BNC connector
Pin No. Function
1 N/C
2 N/C
3 Power Ground
4 Power Input (+12v to +18v dc )
5 Ground
6 N/C
Data
Interface FTT10A
7 (TTL Data Ground)
8 (TTL Data Out)
9 (TTL Data In)
10 FTT10A NODE A
11 FTT10A NODE B
12 N/C
13 N/C
14 N/C
Power Supply
Supply...................................+12 volt to +18 volt at 250mA
Connection ...........................Connector Strip
Pin 3 Gnd, Pin 4 Power Input
Dimensions
See Drawing Above
Mounting Details
See Drawing Above
/