AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 1 of 2 D03120-02
AMG2246S
Instruction Sheet
AMG2246S Single Fibre Standalone Video Transmit + Bi-directional Audio + FTT10A
Video In
Opto IN / OUT
SYSTEM 2000
2200
Video Transceiver
134mm
148mm
7mm
39.5mm
79mm A A
PL1
PIN 1
PIN 14
Video Connection
Connectors ...........................75 ohm BNC Socket.
Input Impedance...................75 ohm terminated.
Input Level ...........................1 volt p-p nominal.
Frequency Response.............10Hz to 6MHz min.
Optical Connection
Connector .............................ST Style (1 off)
Opto Out Launch Power
50/125............................-20dBm. min.
62.5/125.........................-17dBm min.
Wavelength...........................850/1300nm (single fibre) nominal.
Data Connection
Connector .............................Push-in connector strip - 14way
(Solid conductors 0.5mm2(20 awg) can be connected by simply push fitting
into the appropriate connection hole. Smaller conductors and wires (up to
0.5mm2, 20 awg) are inserted into the connection space whilst depressing the
orange lever. Wire or conductors should be stripped back to a length of
11mm. Use a small screwdriver to depress the orange lever to release the
connection.)
AMG Systems Ltd. reserves the right to make changes to this document without notice.
The information herein is believed to be accurate. No responsibility however is assumed
by AMG for its use.
Page 2 of 2 D03120-02
Pinout ...................................See Below – Note Pins number from the BNC Connector
Pin No. Function
1 AC Power In
2 AC Power In
3 Power Ground
4 Power Input ((+12v to +18v dc )
5 Ground
6 Audio Input
Data
Interface FTT10A
7 (TTL Data Ground)
8 (TTL Data Out)
9 (TTL Data In)
10 FTT10A NODE A
11 FTT10A NODE B
12 Ground
13 Audio Output (+)
14 Audio Output (-)
Power Supply
Supply...................................+12 volt to +18 volt at 250mA
Connection ...........................Connector Strip
Pin 3 Gnd, Pin 4 Power Input
Dimensions
See Drawing Above
Mounting Details
See Drawing Above
/