2. Fishbone Offroad
  3. FB22032

Fishbone Offroad FB22032 Installation guide

  • Hello! I've reviewed the installation instructions for the FISHBONE OFFROAD Rear Bumper JK Wrangler w/ LED's. This document details how to install the bumper, wire the LEDs, and mount the included D-rings. It emphasizes using a two-person lift due to the bumper’s weight and suggests using a relay when connecting to reverse lights. I'm ready to address any questions you have about this installation.
  • What tools are required for installation?
    What is included in the kit?
    How should I wire the LEDs?
FB22032
Jeep® JK Wrangler
Rear Bumper w/ LED’s
2203200
REQUIRED TOOLS
18mm Socket
18mm Wrench
KIT CONTAINS
M12 x 120mm Hex Bolt
M12 x 35mm Hex Bolt
M12 Lock Washer
M12 Flat Washer
Nut Plate
QTY
4
4
8
8
2
FB22032
Jeep® JK Wrangler
Rear Bumper w/ LED’s
1 2203200
1) REMOVE YOUR FACTORY BUMPER
Begin by removing your factory bumper.
2) INSTALL YOUR BUMPER
Insert the nut plates into your Jeep’s frame rails.
2 PERSON LIFT
WITH THE WEIGHT OF THIS REAR BUMPER, IT IS
HIGHLY ADVISED TO HAVE HELP WHEN
INSTALLING THE BUMPER!
With the help from a second pair of hands, lift the
bumper up to the frame of the Jeep. Using a short
12mm bolt, lock washer, and washer, loosely fasten
the bumper brackets to your frame rail. Do not
tighten yet, as you may need to adjust the bumper
when installing the long 12mm bolts near the hitch.
Once all four (4) short bolts are loosely in place,
install the remaining four (4) bolts, lock washers,
and flat washers, through your rear crossmember
and into the rear bumper.
3) TIGHTEN ALL BOLTS.
4) MOUNT THE SUPPLIED D-RINGS
5) RUN YOUR WIRING
Wire your new LEDs to turn on with your reverse
lights or to an AUX switch inside your Jeep.
NOTE:
We suggest using a relay if you want to tap into
your reverse lights. We do not recommend
powering your new LED lights from your factory
reverse lights.
6) ENJOY YOUR NEW FISHBONE OFFROAD BUMPER!
/