2. Fishbone Offroad
  3. FB22179

Fishbone Offroad FB22179 Installation guide

  • Hello! I've analyzed this installation instruction manual for the Fishbone Offroad Rear Bumper Delete for Jeep Wrangler JL. It provides a step-by-step guide with images and a list of required tools and parts. I'm ready to answer your questions about the installation process or any other aspect of this product.
  • What tools are required for installation?
    What is included in the kit?
    Where can I find additional help?
FB22179
Jeep® JL Wrangler
Rear Bumper Delete
2217900
REQUIRED TOOLS
18mm Socket
21mm Socket
Ratchet
KIT CONTAINS
Rear Bumper Delete
Nut Plate
3/4” D-Ring
M12 Flat Washer
M12 Lock Washer
M12 – 1.75 x 45mm Hex Bolt
QTY
1
1
2
2
2
2
FB22179
Jeep® JL Wrangler
Rear Bumper Delete
1 2217900
1) REMOVAL
Remove your existing rear bumper. We have a
video to assist if needed, linked below.
JL Stock Rear Bumper Removal: A Step-By-Step
Guide:
https://www.youtube.com/watch?v=6veBI3rXBSw
2) INSTALL
Place the provided nut plate in the passenger side
frame rail.
Place your rear bumper delete onto the frame, so
the left and right bolt holes and slots line up.
Loosely reinstall the factory bolts into their previous
location, 4 21mm bolts on the driver side, and 2
18mm bolts on the passenger side. Also, loosely
install the 2 provided bolts on the bottom of the
frame rail on the passenger side into the nut plate.
FB22179
Jeep® JL Wrangler
Rear Bumper Delete
2 2217900
3) TIGHTEN
With the delete still loose, slide it around so that it
sits on the frame as desired. While holding it in
place, begin tightening the bolts with an 18 and
21mm socket.
ENJOY YOUR NEW FISHBONE OFFROAD JL REAR
BUMPER DELETE!!!
/