Page is loading ...
Questions about installation or product details? Contact our Tech Support team at 940-783-9914
Part# 31307 & 31308: Works on: Ford Mustang (Hard Top):
2005-2009 & 2010-2014
Custom A-Pillar Pod
Installation Instructions
WHAT’S INCLUDED:
Pod Adapter
A-Pillar Pod
STEP 1:
Remove side panel.
STEP 2:
If installing another tuner
install the appropriate pod
adapter at this time. LWTS+
requires part # 30604 and
GTX requires part # 30605,
which is not included. Follow
instructions on installing the
located on the inside of the
packaging card. If you have
stock speakers be sure to
reconnect them at this time.
GT Head Unit
GT Custom Pod Adapter
Custom Gauge Pod
(To OBDII Adapter Plug)
Main Harness
Main Harness Plug
Questions about installation or product details? Contact our Tech Support team at 940-783-9914
31307-99_v1.2
STEP 4:
STEP 4:
STEP 3:
STEP 4:
STEP 5:
Clean OEM A-Pillar with alcohol so surface is prepped for the double sided tape.
Peel back adhesive backing and install cus-
tom pillar pod. If tape does not hold the in-
cluded push rivets will need to be installed.
Remove both the OEM pillar and place the
custom pillar on the OEM pillar. Drill four
3/16” holes through both pillars. Two at the
top and two at the bottom on either side of
the pillar assembly. Install push rivets and
then reinstall the pillar assembly. If cables
are pushing on the custom pillar cut relief
cuts in the OEM pillar.
Finish installation and install side panel.
/
