BLOTZ B28-VSF-003 Assembly Instructions

Type
Assembly Instructions
Gun Turret
B28-VSF-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the two pieces of the central spindle and
glue them together to form a X shape.
Take the top and base from the sprue. Put the base
(the larger one) to one side for now.
Turn the base over and glue the spindle into place.
Take the main gun piece and four barrel pieces.
Carefully glue these into the space provided.
Take the pieces shown above.
Turn the round piece over and glue the support to
the back as shown.
Take the pieces shown above.
Glue them together to form a stack, using the
support to help align them.
Now get these pieces
..and add them to the stack.
Glue the last four slices onto the stack.
Take the spindle you made earlier.
Place (do not glue) the stack onto the spindle.
Glue the base piece to the spindle, ensuring you
do not get any glue on the stack.
Turn the whole thing over andyou have your gun
turret.
  • Page 1 1
  • Page 2 2

BLOTZ B28-VSF-003 Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI