2. Design House
  3. 520379

Design House 520379, 520387 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Design House 520379 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
KIMBALL 3LT ISLAND LIGHT
ASSEMBLY/INSTALLATION INSTRUCTIONS
WARNING: Risk of Fire. Min 75ºC supply conductors. Consult a qualied electrician to ensure correct
installation.
Turn off the main power at the circuit breaker before installing the xture, in order to prevent possible
shock.
#520379
Customer Service 1-800-558-8700
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualied electrician.
Remove the xture and the mounting package from the box and make sure that no parts are missing by
referencing the illustrations on the installation instructions.
Phillips screwdriver.
CAUTION
GENERAL
TOOLS REQUIRED
ASSEMBLY AND INSTALLATION
ASSEMBLY AND INSTALLATION
(CONT.)
Please read carefully and save these instructions, as you may need them at a later date.
Turn off the power at fuse or circuit breaker.
Turn on the power at fuse or circuit breaker.
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
JUNCTION BOX
MOUNTING SCREWS
WIRE NUTS
CROSS BAR
GROUND SCREW
BALL NUTS
STEMS
FIXTURE
SHADE
FIXTURE SCREWS
#520387
1. Gently take all parts out of the package, lay them on a smooth surface, unscrew the BALL NUTS
and the FIXTURE SCREWS. Attach the CROSS BAR to the JUNCTION BOX using (2) MOUNTING
SCREWS.
2. Install STEMS to the FIXTURE based on the desired length of the item, adding CEILING PLATE once
nished.
3. Make wire connections with WIRE NUTS:
A - Connect the black wire from Fixture to the black supply wire.
B - Connect the white wire from Fixture to the white supply wire.
C - Attach the xture ground wire to the CROSS BAR with the green GROUND SCREW. Then
connect it to the supply ground wire with a WIRE NUT. Carefully tuck wires back into the JUNCTION
BOX.
4. Attach the CEILING PLATE to the CROSS BAR through SCREW HOLES as shown, and secure it
with BALL NUTS.
5. Attach the SHADES to the LAMP HOLDERS and secure it with SOCKET RINGS.
6. Install BULBS (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
SOCKET RING
BULB (not included)
A
B
C
SCREW HOLES
CEILING PLATE
Item # 520379 (KIMBALL 3LT ISLAND LIGHT GAL)
Item # 520387 (KIMBALL 3LT ISLAND LIGHT BRZ)
/