DOVE CREEK 1LT WALL MOUNT
ASSEMBLY/INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts are
missing by referencing the illustrations on the installation instructions.
ASSEMBLY AND INSTALLATION
GENERAL
TOOLS REQUIRED
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent
possible shock.
Philips Screwdriver.
Turn off the power at fuse or circuit breaker.
1. Before beginning the installation, carefully unpack and identify all parts.
2. Using (2) JUNCTION BOX SCREWS, securely fasten the CROSSBAR to the
JUNCTION BOX.
3. MAKE THE CONNECTIONS: Attach the FIXTURE GROUND WIRE to the
CROSS BAR with GREEN GROUND SCREW. Then connect it to the SUPPLY
GROUND WIRE with a wire nut. Using WIRE NUTS, connect the SUPPLY
WHITE WIRE(S) to the FIXTURE WHITE (or RIBBED) LEAD(S); Connect the
SUPPLY BLACK (or RED) WIRE to the FIXTURE BLACK (or SMOOTH)
LEAD(S). Wrap all connections with approved electrical tape.
4. Place the WALL PLATE over the CROSS BAR and secure it with (2) LOCKING
BALLS.
5. Locate the GLASS SHADE and slide it over the SOCKET. Thread the SOCKET
RING onto the end of the SOCKET. Hand tighten until snug.
6. Install LIGHT BULB (Sold separately). Use 1 x 60W watt Max (Medium base)
bulb or energy saving equivalent. DO NOT exceed the maximum wattage.
Turn on the power at fuse or circuit breaker.
Customer Service: 1-800-558-8700
IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,
CONSULT A LICENSED ELECTRICIAN.
#577981