Keeney 4815ASN Installation guide

Slip joint connection:

(Discard extra nut and short tailpiece insert if included)

1. Turn off water at the tap.

2. Remove old end outlet tee and tailpiece.

3. Remove top nut A and washer B on new tee.

4. Place nut A and poly washer on sink tailpiece as illustrated.

5. Remove side nut C and washer D and place on waste drain tube.

6. Place nut and washer from J Bend onto tee.

7. Position tee. Hand-tighten nuts. Run water to test for leaks.

Direct connection:

1. Turn off water at the tap.

2. Remove old end outlet tee and tailpiece.

3. Remove top nut A and washer B.

4. Invert nut A and drop insert into it.

5. Attach strainer using rubber washer.

6. Put second nut E and poly washer F on insert.

7. Put side nut C and washer D on waste drain tube.

8. Place nut and washer from J Bend onto tee.

9. Position tee. Hand-tighten nuts. Run water to test for leaks.

4815ASN/1815SN

This manual is also suitable for

Download PDF