XDesign XD000039 User guide

Category
Screen protectors
Type
User guide

This manual is also suitable for

INSTALLATION
GLASS SCREEN PROTECTOR
XDesign
8. Tap the center of the screen
protector. The protector will begin to
adhere to the screen. If there are any air
bubbles, push your finger down and
drive the bubbles out towards the
closest edge.
FAQ
Why doesn't it t my phone?
Please check if the screen protector type you purchased matches the size of your phone.
Please align the top of the frame and size it up carefully.
I see air bubbles. How can I remove them?
Clean the screen very carefully and use the dust-absorber sticker to get rid of the dust.
Also, use the sticker to eliminate the dust from the back of the screen protector.
Will this screen protector interfere with my phone’s sensor or facial recognition?
Don’t worry. There will be no interference. This screen protector is compatible with all
iPhone features.
Glass Screen Protector
XDesign
6. Without touching the sticky side of
the protector, gently tap the top of the
protector to the top side of the frame
making sure the protector falls exactly
between the frame.
1. Take the wet wipe
and use it to remove any
dirt on the screen.
2. Then take the dry
wipe and make sure all
dust and liquid has been
removed.
4. Dab the sticker side of
the dust-absorber to
remove any amount of
debris on the screen.
9. Congratulations. Your phone is
now protected!
5. Remove the bottom protective
layer by carefully pressing down on
the indicated tab until the two
seperate.
7. Carefully drop the screen
protector onto the screen. Always
make sure the top edge of the
screen protector is adjacent to the
top side of the assistive frame.
3. Place the protector
guidance frame on top of
the phone and mount it on
the phone securely.
  • Page 1 1

XDesign XD000039 User guide

Category
Screen protectors
Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI