Outdoor Distinctions MB-RFLEX6V1 User guide

Type
User guide
ODRF_08_16
Installaon Instrucons
English
1
Tape measure
Power Screwdriver and Phillips Bit
Pencil
Tools Required
Item Quanty Descripon
A. 1 ReFlex-rotang metal bracket
B. 1 Wood Plaorm
C. 4 ReFlex Aachement Screws 2.5”
D. 1 #2 Square Bit
E. 4 Mailbox - Side Aachment Screws 1.25”
F. 4 Mailbox - Side Aachment Screws 2.25”
G. 4 Mailbox - Spacers (Oponal)
H. 4 Mailbox - Internal Aachment Screws .75”
Parts Included with this Product
Congratulaons on your purchase of the ReFlex-rotang mailbox bracket.
Before you begin, please refer to the parts list to ensure all materials needed for assembly have been received.
Quesons? Contact your local Outdoor Disncons Dealer or visit www.outdoordisncons.com
Outdoor Disncons representaves are available M-F 8:00 a.m. to 5:00 p.m. EST. at 844.345.2424.
B.
A.
E.
G.
F. C.
Read each step thoroughly prior to installing:
Determine mounng opon
1. Horizontal Mount
2. Post Mount
1. Horizontal Mount
Step 1 - Conrm required
gap between back of mailbox and
vercal post for rotaon. See
minimum gap reference.
Step 2 - Secure ReFlex using Part C
quanty 4 screws with Part D #2
Square screwdriver bit and Power
Screwdriver.
Step 3 - Posion round cutout on
Part B over fulcrum on Part A.
Step 4 - Mailbox Aachment
Side Mount Mailbox (Preferred Method)
Standard 6” T1 Mailbox: Posion
mailbox side mounng holes
with oblong openings on Part
A. Secure mailbox using Part E
quanty 4 screws into Part B.
Oversized 8”+ T2/T3 Mailbox: Posion mailbox side
mounng holes with oblong openings on Part A. Using Part
G quanty 4 spacers between Part A and mailbox boom
side lip, secure mailbox using Part F quanty 4 screws into
Part B. *Spacer gap will vary depending on mailbox width.
Internal Mount Mailbox
- Secure Part B to Part A through oblong opening and into
wood using Part E quanty 4 screws. Center mailbox over
mailbox plaorm and aach with Part H quanty 4 Pan-
head screws.
2. Post Mount
Step 1 - Center 4x4 Mounng Base Plate over wooden
post, aligning corners.
Go To Step 2 above to complete installaon as the
process is the same.
2.
1.
6” T1 Mailbox = 1” Minimum
8” T2 Mailbox = 1.5” Minimum
Step 2
Step 3
Step 1
2.
H.
D.
  • Page 1 1

Outdoor Distinctions MB-RFLEX6V1 User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI