i3 International C-AX401C1MN User manual

Type
User manual

This manual is also suitable for

i3 International C-AX401C1MN is a versatile network camera designed for professional surveillance applications. It captures high-quality video footage in various lighting conditions, making it ideal for both indoor and outdoor use. With its motion detection and alarm capabilities, it can actively monitor areas and alert users of any suspicious activity. Additionally, the camera's two-way audio and SD card support enable remote communication and local storage of recordings.

i3 International C-AX401C1MN is a versatile network camera designed for professional surveillance applications. It captures high-quality video footage in various lighting conditions, making it ideal for both indoor and outdoor use. With its motion detection and alarm capabilities, it can actively monitor areas and alert users of any suspicious activity. Additionally, the camera's two-way audio and SD card support enable remote communication and local storage of recordings.

C-AX401C1MN
Network Camera User Guide
WARNING:
Before attempting to connect or operate this product, read these instructions carefully.
Save this manual for future use.
To avoid electrical shock and to preserve the product warranty, DO NOT disassemble the camera.
Refer servicing to qualified personnel only.
CONTENTS
PRECAUTIONS
NOTES OF USE
NETWORKING
SETTINGS
SPECIFICATIONS
1
2
4
6
8
1
PRECAUTIONS
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to cause
harmful interference, in which case users will be required to correct the
interference at their own expense.
FCC Caution:
To ensure continued compliance, use only shielded interface cables
when connecting to computer or peripheral devices. Any changes
or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
The serial number of this product may be found on top of the unit. It is
recommended that you note the serial number of this unit in the space
provided and retain this book as a permanent record of your purchase to
aid identication in the event of theft.
Model No.
Serial No.
Date of Purchase:
2
NOTES OF USE
Power Supply
Ensure the supplied voltage meets the power consumption requirements of this
camera before powering the camera on. Incorrect voltage may cause irreparable
damage to the video camera and will effectively void the camera warranty
Operating or storage location
Avoid shooting very bright objects (such as light ttings) for an extended pe-
riod. Avoid operating or storing the unit in the following locations:
Extremely hot or cold places (operating temperature: -10
o
C to +50
o
C)
Close to sources of strong magnetism
Close to sources of powerful electromagnetic radiation, such as
radios or TV transmitters
Close to humid or excessively dusty places
Where exposed to mechanical vibrations
Close to uorescent lamps or objects reecting light
Under unstable light sources (may cause ickering)
Transportation
When transporting the camera, repack it as originally packed at the
factory, or in materials equal in quality.
Cleaning
For maximum optical clarity, the dome cover must remain clean. Use
a soft, dry cloth to remove nger prints or dust from the dome cover.
Use a blower to remove dust from the lens.
Clean the body with a soft, dry cloth. If it is very dirty, use a cloth
dampened with a small quantity of neutral detergent, then wipe dry.
Do not use volatile solvents such as alcohol, benzene, or thinners,
as they may damage the surface nishes.
Servicing
To avoid electrical shock and to preserve the product warranty, DO NOT
disassemble the camera. Refer servicing to qualied personnel only.
3
NOTES OF USE
Included in the box
1. Camera (C-Ax401C1MN)
2. Software CD
3. Quick start guide
Feature & Functions
SD card slot
Power (White:-/Red:+)
Network
Default Button Reset Button
Power Indicator
TV/IP Select
AL. I(Alarm In) &
AL. O(Alarm Out)
Audio In
(White)
Audio Out
(Black)
Power 24VAC 12VDC
Red 24VAC Positive
White 24VAC Negative
4
NETWORKING
Connecting to a camera using a network
1. Connect the camera to a PoE (Power over Ethernet) enabled switch or
router using a RJ45 Cat5 or Cat6 connection cable.
1.1. Connect the users computer to the PoE switch or router.
OR
1. Connect the camera to a personal computer or a switch or router using
a RJ45 Cat5 or Cat6 connection cable.
1.1. Connect a properly grounded 24Volt AC power source to the camera.
Operating or storage location
2. Use the Annexxus Finder located on this CD to nd the Camera’s IP
address (default is 192.0.0.64)
3. Open an internet browser and type the IP Address of the camera into
the address bar. Hit enter.
5
NETWORKING
4. If you cannot connect try the following:
4.1. Wait. sometimes the router or switch will take a few seconds to
refresh the routing table
4.2. Go to control panel, network connections, and properties of the LAN
or WAN the camera is connected to. Under the Internet Protocol
(TCP/IP) properties, change the 2nd section of the IP to match the
same as your camera EG IP: 192.0.0.90 Camera: 192.0.0.64
4.3. Check the connection. Ensure all cables are properly connected.
5. Login to the camera using the proper username and password
5.1. Default Username: admin
5.2. Default Password: 1234
Network connections
6
SPECIFICATIONS
The specifications are subjects to be change without notice
Camera
Synch System Internal
Day & Night (IICR) D/N (auto/manual)
Image Sensor 1/3" progressive transfer CCD
Number of Effective Pixels Full scanning mode: 1280 (H) x 960 (V)
Lens Optional Mega-pixel lens: f=2.4~6mm, F1.2, f=3.0 ~ 8 mm, F1.0,
f=5~50mm F1.4
Frame rate SXVGA 1280x960 @15 fps; VGA 640x480 @30 fps,
QVGA 320x240 @30 fps
Motion detection Yes
Image Compression Method MJPEG / MPEG4
Min. Illumination Day: 0.4 lux. Night: 0.06 lux.
White Balance 2500K~10000K
Angle of view 27.73~100.18 (H) X 20.45 ~ 73.33 (V)
Video Output 1 BNC for VGA composite video (PAL/NTSC)
QVGA 320x240 @30 fps
Gamma correction 0.45
Software
Web Browser IE 6.0 or above, Netscape 7.0 or above
Password Protection Multiple password for user to login
Communication
Protocol TCP/IP, UDP/IP, HTTP, SMTP, DNS, DHCP, NTP, DDNS, FTP, RTP
Network
Ethernet 1 x 10/100 base-T Ethernet connection for LAN/WAN
Image compression method MJPEG / MPEG4
Protocol TCP/IP, UDP/IP, HTTP, SMTP, DNS, DHCP, NTP, DDNS, FTP, RTP
Connectors Screw less Terminal Jack
Environment
Weight 470g (1 lb)
Operating Temperature -10ºC ~ 50ºC (14ºF~122ºF)
Storage Temperature -20ºC ~ 60ºC (-4ºF ~ 140ºF)
Humidity 80% RH or less
Dimensions 180mm x 66mm x 55mm (7.09” x 2.6” x 2.17”)
SPECIFICATIONS
Interface
Network Port RJ45 with LEDs
Video Port BNC
Audio IN & OUT Ports 3.5mm phone jack
Alarm IN & OUT Ports 1x Alarm In / 1x Alarm out
Electrical
Audio Two-way mono audio; Full-duplex
Alarm Yes, 1 x Alarm in, 1 x Alarm out
SD card slot Yes, SD card up to 2GB supported
Power Requirement DC12V/AC24V/PoE+
Power Consumption Approx. 8W
Electric Shutter PAL:1/25, 1/50, 1/120, 1/250,1/1000, 1/10000 sec
NTSC:1/30, 1/60, 1/120, 1/250,1/1000, 1/10000 sec
Black light compensation Off, BLC1~BLC6, Auto
i³ INTERNATIONAL INC.
1.866.840.0004
www.i3international.com
Canada 780 Birchmount Road,
Unit 16, Scarborough,
ON, M1K 5H4
U.S.A. 440 Lawrence Bell Drive,
Suite 16, Williamsville
NY, 14221
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

i3 International C-AX401C1MN User manual

Type
User manual
This manual is also suitable for

i3 International C-AX401C1MN is a versatile network camera designed for professional surveillance applications. It captures high-quality video footage in various lighting conditions, making it ideal for both indoor and outdoor use. With its motion detection and alarm capabilities, it can actively monitor areas and alert users of any suspicious activity. Additionally, the camera's two-way audio and SD card support enable remote communication and local storage of recordings.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI