DECAL:

DY8968

Dynam RC

dynam-rc.cn

of

This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.

over

DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT

Control Throw Setting Suggestion

lnsert the pushrod into elevator quick-controller

and tighten the screw(the servo should be in

center position).

Install the propeller. Install spinner with PA2.5*8mm screws.

12

Secure elevator servo horn with PM2*14

15

14

9

4

Cut the lines with knife to ensure

the position of rear wheel.

Glue the cover in position.

Install the PWM3*25mm screws

on the undercarriage.

Secure the horn of nose wheel

with PM3*6mm screw.

Thread the landing gear under

Secure the wing onto the fuselage

with PM3*35mm screws.

PM3*35mm

DY-6015 11.1V 2200mAh

25C Battery

BM3715A-KV1050

Brushless Motor

BM3715A-KV1050-Shaft

Motor Shaft