DECAL:
DY8955
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
CENTER OF GRAVITY(C.G.)
DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT
SPARE PART LIST:
Item:DY8955
Servo: 9gx4pcs
Battery: 11.1V 2200mAh Li-Po, 20C
Wingspan: 1270mm (50in)
Overall Length: 980mm (45.8in)
Wing Loading: 42.2g/d
Speed Controller: 40A Brushless
Motor Size: BM3715-KV900 Brushless Outrunner
Flying Weight: 1250g (49.5oz)
DY-3003 Glue DYR-2001 2.4G Receiver
Push rod
GBY-10
DY-1007 9g Servo
GBY-08 Wing struts
GBY-09
Blade Holder
BM3715-KV1050-Shaft
Brushless Motor
DY-6006
11.1V 2200mAh 20C Li-Po Battery
DECAL
GBY-12
Battery cover
GBY-14
GBY-11 glass fibre tube
CowlGBY-01
FuselageGBY-02
wing setGBY-03
GBY-04 Vertical stabilizer
ElevatorGBY-05
CanopyGBY-06
PropellerDYP-1019 12x6
Landing gears setGBY-07
DY-3006 Motor Mount
GBY-15 Screw set
GBY-13
Plastic Tab
ASSEMBLY:
Install the propeller.
Fix the wing struts with PA2.5x6mm
screws.
It shows how to open the canopy.
Install elevator push rod as shown.
Install rudder push rod as shown.
Install tail wheel with PA2x6mm screws.
Insert the horizontal stabilizer and
vertical stabilizer in place.
Fix the wing on fuselage with
PM3x35mm screw.
Fix the stabilizers with PA2.3x20mm
screw.
Connect the aileron servos with
Y wires.
Insert ΓΈ8x400mm glass fiber tube into left and
right wing,and connect the wings together.
Install the landing gear with PWA
3*10mm screws.
1
2
3
4
5
7
11
9
10
8
12
6
NR 718Y
NR 718Y
NR 718Y
NR 718Y
Suggest Control Throw Setting
Elevator Aileron Rudder
11.1V 2200mAh
Li-Po 20C
(12x6)
ESC-40A
ESC-40A
2200mAh 11.1V
20C Discharge
Lithium-polymer Battery
Rechargeable Cells
Use li-po charger only
The ideal C.G. position is 50~55mm behind the
leading edge measured at where the wing meets
the fuselage.In order to obtain the C.G.
specified,add weight to the fuselage or move the
battery position. Check the C.G. before flying.
50 55
50 55
Skylord 40A ESC