Dynam Sbach 342 1250mm Wingspan - PNP, Sbach 342 1250mm Wingspan - BNP, Sbach 342 1250mm Wingspan - SRTF User manual

  • Hello! I am an AI chatbot trained to assist you with the Dynam Sbach 342 1250mm Wingspan - PNP User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
2
3
4
8
9
6
7
5
10
11
12
SPARE PART LIST:
DY-3003 Glue
Sbach-08 Landing Gear
DY-6015 14.8V 2200mAh
25C Battery
Sbach-04 Vertical Stabilizer
DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT
CENTER OF GRAVITY(C.G.)
DECAL:
DY8945
Wingspan
Length
Flying Weight
Wing Area
Wing Load
Radio System
Power
Battery
: 1250mm (49.2in)
: 1235mm (48.6in)
: 1450g (51.2oz)
: 31.2dm²
: 46.5g/dm²
: 4 Ch TX and 7 Ch RX
: Brushless System
: LIPO, 2200 mAh, 14.8V
ASSEMBLY:
Control Throw Setting Suggestion
Elevator Aileron Rudder
14.8V 2200mAh
Li-Po, 25C
(13x6)
Lithium-polymer Battery
2200mAh 14.8V
25C Discharge
Rechargeable Cells
Use li-po charger only
MOTOR
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
75 80
75 80
1 2 3 4 5
6 7 8 9
11
12
13 14
Install the landing gear with M3*10mm screws.
Install the landing gear cover in place with
Double-sided tape.
Insert the fiber glass tubes into the wings and
Install the wings onto the fuselage.
Secure the wings with PA2.3*20mm screws. Connect the aileron servos with the Y wires.
Install the horizontal stabilizer and vertical stabilizer.
Secure the stabilizers with PA2.3*20mm screw.
Install tail wheel with PA2*6mm screws.
Connect the pushrod on the elevator and secure the
screw (the servo should be in the center position) .
Connect the pushrod on the rudder and secure the
screw (the servo should be in the center position) .
10
Install the propeller. Install the spinner with PA2*6mm screws. Glue the side force generator (SFG). Open the canopy this way.
Sbach-01 Cowl
Sbach-09 Spinner
Sbach-05 Elevator
Sbach-03 Wing
Sbach-02 Fuselage
Sbach-06 Canopy
Sbach-13 Decal
DYR-2001 2.4G Receiver
DY-3001 Quick-controller
DYP-1019 13*6 Propeller
DY-1007 9g ServoDY-1009 17g Servo
BM3720A-KV650
Brushless Motor
BM3720A-KV650-Shaft
Motor Shaft
DYB-05 5#Pilot
1
2
3
4
11
10
7
8
12
5
6
9
DYBH-1000 blade holder Tab A
Sbach-12 Push Rod
DY-3004 Servo Horn
Sbach-15 Cockpit
Sbach-16
Screw set
DY-3006
Motor Mount
Sbach-14
Plastic Tab
skylord
50A ESC
DTM-T006 6A Transmitter
ESC-50A
ESC Skylord 50A
/