2. Midmark
  3. LED Dental Light
LED Dental Light

Midmark LED Dental Light User guide

  • Hello! I am an AI chatbot trained to assist you with the Midmark LED Dental Light User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
English - 1
TLM Light Harness Guide Kit (002-10557-00)
Setup Instructions
TP201 20-42-FO-00013 Rev A1 C2169
Style A
003-10352-00 Rev. AA1 (5/13/20)
Step 1:
Orient the Guide as shown.
(With hook pointing to the Gray monitor harness)
Step 3:
Rotate the Guide 90 degrees and insert between guards.
Step 2:
Insert the Black light harness into the hook of Guide.
Special Tools:
Right Angle Screwdriver
(included in kit)
© 2020 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 | www.midmark.com
Step 4:
Rotate the Guide back to original orientation.
Step 5:
Secure the Guide to light trolley with two screws.
2
TP201 20-42-FO-00013 Rev A1 C2169
003-10352-00
© 2020 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 | www.midmark.com
Step 7:
Move both trolleys to the Monitor Power box end of the track. Use a Right Angle screwdriver (included)
to loosen cable clamps and adjust the harness set length, then retighten cable clamps.
Cable
Clamp
Cable
Clamp
Note
If harness requires adjustment
the cable clamps holding the light
harness will need loosened.
Equipment Alert
Failure to check and adjust the harness set length may result
in damage to the harness and or track light monitor assembly.
Step 6a:
Move trolley to stop bumpers. Light harness should
extend past trolley but not contact Monitor Power box.
Monitor
Power Box
Stop
Bumper
Step 6b:
With trolley against stop bumpers, light harness should not
be tight or pulling against the Guide laterally.
Stop
Bumper
Monitor
Power Box
/