SSWS004_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
BRACKETS FOR LARGE PICK-UP DECK
COMPLETION SET
SSWS004
ENG
1
60 min
IMPORTANT WARNING!
Thank you for purchasing Front Runner Brackets for Large Pick-Up Deck Completion Set.
Before you start, take a moment to familiarize yourself with this Fitting Intruction and the components received.
Refer to Page 2 for a list of all the components, quantities and tools required.
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE.
IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH.
YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER PRODUCTS TO YOUR VEHICLE. CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND DAMAGE.
THEREFORE YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE.
IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES,
YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
SSWS004_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
2
TOOLS NEEDED
10MM 10MM
3
1 1 X Side Wing Fixed - Long
2 1 X Side Wing Fixed - Long & Wide
3 2 X Rear Wing Fixed - 1LH & 1RH
4 1 X Rear Wing Middle Stiffener
5 1 X Side Wing Fixed - Short & Wide
6 2 X Side Wing Fixed - Short & Narrow
7 3 X Side Wing Slide - Narrow
8 2 X Side Wing Slide - Wide
9 2 X Rear Wing Slide - 1LH & 1RH
10 44 X M6x16 Hex Bolt
11 20 X M6 Spring Washer
12 68 X M6x19x1ss Flat Washer
13 24 X M6 Nyloc
14 2 X M6 Cage Nut
IN THE BOX
FIGURE 1.1
7
1
10
11
12
4
10
13
3LH 3RH
8
2
9LH
12
14
9RH
5
8
6
6
7
7
GET ORGANIZED
1
Here is what you are looking at for SSWS004
SSWS004_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
3
PREPARATION
2
2.1
2.2
13 12
7
10
11
10 13
12
8
10 1312
7
5
13 12 10
2
8
Note notch for pairing
parts 2 & 8
Note notch for pairing
parts 5 & 8
ASSEMBLY OF 2 & 5 ( REFER TO 3.1 FOR PLACEMENT)
ASSEMBLY OF 1 & 6 ( REFER TO 3.1 FOR PLACEMENT)
SSWS004_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
4
3.1
FIT AND SECURE
2
6
1
2
3LH
4
3RH
5
6
FIT AND SECURE
3
2.3
9LH 10 12 9RH 13
3LH 3RH 4
14
ASSEMBLY OF 3LH, 3RH & 4 ( REFER TO 3.1 FOR PLACEMENT)
SSWS004_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
5
FIT AND SECURE
3
3.3
10
11
10
11
12
12
4
Remove & Refit
Top 4 Bolts
3.2
Repeat this step
for fitment of
Assemblies 1 and 6
SSWS004_REV_A00 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
5
Congratulations you have completed your installation, take a step back and admire your work.
FIT AND SECURE
3
4
COMPLETION
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
5
Now's the time to visit your favorite Front Runner Dealer in person or online.
4.1
12
10
11
Position Second
Position First
3.4
Remove & Refit
Top 2 Bolts
/
