2. FuzzDog
  3. ProtoBuddy Breadboard

FuzzDog ProtoBuddy Breadboard Operating instructions

  • Hello! I've reviewed the user manual for the Pedal Parts Ltd. Proto Buddy breadboard set. This document explains how to assemble the device, covering everything from mounting the jacks and switch to connecting basic components. I'm ready to answer your questions about this product and its setup.
  • Where does the TRS jack go?
    Where does the mono jack go?
    What type of toggle switch is needed?
Proto Buddy
Sweet little breadboard set up
Contents of this document are ©2022 Pedal Parts Ltd.
No reproduction permitted without the express written
permission of Pedal Parts Ltd. All rights reserved.
This one is pretty simple...
Mount your DC socket.
Mount your jacks -
TRS goes on the input,
mono on the output.
Mount your bypass toggle
switch - DPDT ON-ON.
Solder in the solid core
wires on the two outer
sets of V-G pads.
Solder in your flying leads.
Solder the battery snap
(if you’re adding one) to
the +/- pads next to the
input jack.
Stick your breadboard to
the PCB.
Insert the solid core outer
wires into the +/- points of
the breadboard.
GO!
Your battery will be
disconnected when there’s
no input jack inserted.
/