Riverside Furniture 21566 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the Riverside nightstand models 21566 and 21766. This document outlines the steps for assembling the furniture piece, including attaching the legs and shelf. It also explains how to remove and reinstall the drawer. I'm ready to answer any questions you have about the assembly process or the features of the nightstand.
  • How do I start the assembly?
    How to properly place the shelf?
    How to remove the drawer?
Components and Hardware List
Made in Viet Nam
Page 1 of 1
21566 & 21766
LEG NIGHTSTAND
WOOD TOP & WITH DRAWER
AB C
Assembly Instructions
1 pc.
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment.
ASSEMBLY STEPS:
1. Place the Table Top upside down on a soft surface such as a blanket or carpet. Screw the bolts of the
Center Legs (C) to the Top as shown.
2. Place the Shelf (B) onto the Center Legs, aligning holes at corners as shown.
3. Screw the bolts of the Bottom Legs (D) through the Shelf, into the Center Legs as shown. Tighten hand
snug.
4. Set the completed Night Stand upright. Assembly is complete.
1 pc. 4 pcs.
D4 pcs.
Corinne
Bed Room
FURNITURE
Riverside
To remove the drawer if it ever
becomes necessary:
A. Pull the drawer fully open so the
black latch is visible in the inside
channel of the guides.
B. Release the latches by
simultaneously pushing one lever
up and the other down.
C. At the same time, pulling the
drawer forward until the slides
release.
To reinstall the drawers, carefully
align the channels of both guides
and push drawer back in until
fully closed. Open and close
drawer fully a couple times to
verify proper operation.
/