2. Riverside Furniture
  3. 75809

Riverside Furniture 75809 Assembly Instructions

  • I've reviewed the assembly instructions for the Riverside Furniture End Table 75809. This document outlines the step-by-step process to assemble your new end table, including the necessary hardware and a detailed parts list. I'm ready to answer your questions about the assembly process based on the manual.
  • What is the first step in assembly?
    What components are used to assemble the legs to the table top?
    What tool is used to assemble the shelf to the legs?
Made in Viet Nam
Riata Tables
Assembly Instructions
Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment. Separate, count and check all parts against the Components and Hardware List below.
email: info@riverside-furniture.com
Page 1 of 1
(B) (C)
4mm
Allen Wrench
Bolt:
Ø5/16" x 50mm
(F)
Spring Washer
Ø 5/16" Item #75809
END TABLE
THANK YOU FOR YOUR PURCHASE.
DETAIL A
ASSEMBLY PROCEDURE:
1. Remove the Drawer from the
Table Top (A) and lay the Table
Top upside down on a soft and
smooth surface.
3. Assemble the Shelf (D) to the four Legs (B & C) by
using Bolts (E) Spring Washer (F) & Washer (G)
as shown in DETAIL B, using the Allen key (H).
2. Assemble the Left & Right
Legs (B & C) into the proper
corners of the Table Top (A) by
using Bolts (E) Spring Washer (F)
& Washer (G) as shown in
DETAIL A.
Do not fully tighten Bolts
until after Detail B.
4. Turn the assembled Table
upright and reinstall the drawer.
(D)
BB
/