2. Baso
  3. ZP SERIES

Baso ZP SERIES Installation guide

  • Hello! I've reviewed the installation instructions for the BASO ZPB series Piezo Spark Igniter. This document outlines the proper mounting, installation, and spark gap requirements, as well as a safety warning regarding electric shock. I'm ready to answer any questions you may have about the ZPB1-1, DD2CE-1 models.
  • What igniters can the BASO piezo igniter be used with?
    What should the spark gap be for effective spark ignition?
    Where should the piezo button be mounted?
    What is the warning about pushing the igniter plunger?
Installation Instruction ZPB Piezo
Issue Date June 19, 2019
ZPB Series Battery Operated Piezo Spark Ignition
© 2019 BASO Gas Products 1
Part No. BASO-INS-ZPB, Rev. A www.baso.com
ZPB Series Battery Operated Piezo Spark Ignition
Application
The BASO piezo igniter can be used with any of the
BASO D series igniters or Q pilots/J series pilots that
houses an igniter feature.
Installation
Mount the piezo igniter far enough away from the
burner to eliminate flame or heat damage. Spark gap
from the spark rod to surface or a ground rod should
be at 0.125 or (1/8") gap for effective spark ignition.
0.125
3.18
GAP
Figure 1: DD2CE-1 Igniter
!
WARNING: Risk of Electric Shock.
Do not push the igniter plunger unless installed to a
plate to avoid personal discomfort from shock.
Mounting
Mount piezo button in a convenient location to operate.
Ensure the piezo is mounted to a plate with nut
securing the assembly to the plate (see Figure 2).
Igniter
Box
Metal
Plate
Nut
Push
Button
Ground
Tab
Figure 2: ZPB1-1 Mounting
450 East Horseshoe Road
P.O. Box 170 www.baso.com
Watertown, WI 53094 Printed in U.S.A
1-877-227-6427 (1-877-BASOGAS)
/