Page is loading ...
10mm Grand Hotel Middle
B10-MW-261
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B10-MW-261)
Remove the front wall along with the long and
short side walls from the sprue. You’ll also need
three corner bracers.
Glue the bracers to the rear of the front wall, then
stick the long and short sides to that. Attach the final
bracer to the open end of the long wall as shown
above.
Repeat this process for the other end of the
hotel, ensuring that they mirror each other.
Now remove the back wall, front wall and two straight
supports from the sprue.
Stick the straight supports into the rear of the
back wall, then attach the front wall to them as
shown.
Glue the
end pieces to the
front/back wall
assembly
Remove the three cladding pieces shown above
from the sprue.
Place the middle floor assembly on top of the
completed foyer as this will help when
positioning the cladding on the middle layer.
Starting with the front wall, glue that into position,
then attach the two side pieces as shown.
Next take the front, side and rear wall cladding
and attach each in turn (dry-fitting them first as
the both front and side cladding differ slightly on
each side)
The completed middle section.
/
