2. Carmanah
  3. MX SERIES
MX SERIES

Carmanah MX SERIES Installation guide

  • Hello! I've reviewed the user guide for the MX Series Integrated Beacon Mount Kit. This document provides instructions for installing the beacon mount kit on a pole and includes information about the mounting process, solar panel orientation, and warnings about water damage. I'm ready to answer any questions you might have about the installation process or the device itself.
  • What is included in the Integrated Beacon Mount Kit?
    Can the assembly order be modified?
    What is the recommended orientation for the solar panel?
MX Series
INTEGRATED BEACON MOUNT KIT INSTALL GUIDE
LEVEL 4
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com | carmanah.com
91627REVA
1. Side of pole only: drill holes if through-bolting and/or cable hole required. Install mount onto pole
with suitable fasteners or banding (not included). Remove mount cap and insert nut into channel.
Side of Pole Top of Pole
Assembly order depicted may be modified to suit preference and does not include cable
routing steps.
Top of pole mount and beacon may differ from those shown.
2
INTEGRATED BEACON MOUNT KIT INSTALL GUIDE
LEVEL 4
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | [email protected] | carmanah.com
2
3
4
61
Failure to install gasket could result in water entry
and product damage.
NOTE: READ ALL INCLUDED INSTALL GUIDES BEFORE SYSTEM INSTALLATION
2. Install lock ring (top of pole) or gasket (side of pole) onto mount.
3. Orient and fasten beacon onto mount with nipple and load spreader plate (12" only, comes with
beacon).
4. Assemble power module loosely with lock ring, gasket and nut as shown.
5. Orient solar panel to face south (in North America) and tighten nut.
6. Side of pole only: replace end cover.
/