Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at
1 800 282 9346
(Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Post with Post Caps attached (4)
2. Side Panels (8)
3. 3.5” Stainless Steel Screws (16)
General Information
• Read Instructions through carefully before beginning assembly.
• When assembling components, place on a non-abrasive surface
(i.e. shipping box) to avoid scratching.
• We recommend an area approx 4’x 8’ for unobstructed assembling.
• You should not need to use excessive force when assembling components.
The Versailles Raised Planter Bed
Please read through before starting assembly.
ASSEMBLY INSTRUCTIONS
3
1
Not to Scale
2
1
V1.2/101815
59 in.
59 in.
65.2 in.
65.2 in.
65 in.
9 in.
12 in.
24 in.
56 in.
www.newenglandarbors.com
STEP T WO
If you’ve purchased the Extension Kit (sold separately), Repeat the
steps above. The distance between the posts should be 56 inches
apart.
The Versailles Raised Planter Bed
Extension Installation
6
3
Toll Free Phone: 1 800 282 9346 Toll Free Fax: 1 877 464 9286
www.newenglandarbors.com
3
4
2
STEP ONE
Excavate four, 8-inch holes in a square pattern (60½” x60½”)
as shown aside. Holes are to be 12 inches deep.
Place a post into each of the four holes. The posts will be buried
12 Inches into the ground.
Stack the side panels two high between the posts. You will have
to maneuver the posts to allow room for the side panels to slide
in between. While ensuring the posts and side panels are level,
replace the excavated dirt back and around the holes.
Using the screws provided, fasten the side panels to the posts.
(One screw for each intersection of side panel and post).
Raise Bed Installation
1
2
1
2
12”
8”
60½”
60½”
4
6
/
