Waste Container
Installation Instructions
I-RVKDRB-11
TOOLS REQUIRED:
ESTIMATED ASSEMBLY TIME:
15 minutes
CARE AND MAINTENACE: Clean with a damp cloth and wipe dry
PARTS LIST:
Phillips Head
Screwdriver
Drill
Frame
(2) Uprights
Handle
Waste Container
Rear Basket
(4) Screws
Begin by setting the frame inside the cabinet. Locate the position of where
you would like it to be mounted. NOTE: Look to make sure that there is no
interference with the cabinet door when opening and closing.
With the frame in the closed position, insert the front two screws, making
sure that the frame is square to the front of the cabinet. Then install the 2
rear screws.
1)
2)
With the frame securely in place, slide the frame out of the cabinet and
remove the 2 screws in the rear of the frame as shown.
The rear basket can be installed using these 2 screws as shown.
NOTE: for 16” depth or shorter applications, the rear basket can be left o.
3)
4)
Attach both uprights as shown into the tubes located on the frame.
5)
Finally attach the optional handle and insert waste container. NOTE: Handle
should only be used if you are not using the optional Rev-a-shelf door mounting
kit (sold separately).
6)
©2011 Rev-A-Shelf, Inc. • 12400 Earl Jones Way Louisville, KY 40299 • 1-800-626-1126 • www.rev-a-shelf.com.com
Page is loading ...
-
1
-
2
Rev-A-Shelf RV-12KD-18C S Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
Related papers
-
Rev-A-Shelf RV-8PB-CR S Installation guide
-
-
Rev-A-Shelf 5743-10-CR-1 Operating instructions
-
Rev-A-Shelf 4WCTM-24DM2-162 Operating instructions
-
-
-
-
-
-
Rev-A-Shelf 53WC-1527SCDM-217 Installation guide