Page is loading ...
Hob Separator Plate
CN818061
Assembly
HTPLE02
NOTE: Ensure packaging is disposed of in a safe
environmentally friendly way
Separator plate may not allow use of internal
storage drawer sets
FRONT VIEW
When fitting a hob into a worktop, a heat resistant separator plate is required to isolate the underside of
the hob (unless above an oven).
Note: The plate must allow ventilation for the hob and be easily removed for any service needs.
This assembly guide shows an example method of fitting a separator plate.
Necessary clearance from instruction booklet
C + D = Separator plate fitting depth ‘X’. Use dimension ‘X’ in stage 1 of this leaflet
X
Hob Depth
Hob Protrusion
6mm
‘C’
‘D’
‘B’
‘A’
Worktop Depth
Mark cabinet depths X and cutout section.
X +6mm for the the bracket positions.
Fitting depth depends upon worktop thickness and hob
protrusion depth.
Cabinet width ( minus 130mm )
X
+6mm
Cut out
1
Internal Width
of cabinet
2 2
1
1
2
455mm
Cut front rail as necessary
for hob installation
3
Back
of the
cabinet
Separator Plate
Separator Plate
2
1
X +6mm for
bracket position
Side of
the cabinet
Cut the 6mm board supplied to the internal width of the
cabinet. Fix the panel in place using brackets & screws
(3.5 x 13mm) provided.
Note: Follow the diagram below for number of brackets and
fixing locations.
X
When fitting a timber or laminate
worktop, router the underside as
shown to a depth of 3mm.
5mm from
the moisture
barrier
When fitting granite worktops, the front rail of the cabinet will need to be
routered (3mm in depth) at set intervals to allow for airflow (as above
timber / laminate worktop method is not possible).
Note: Do not router the full length of the front rail, as this is required as
support for the granite worktop.
Depending upon application a granite support bar may need to be
fitted if front rail is reduced in size (and strength) significantly.
Routered sections
Cut out as necessary for gas pipe connection etc.
35mm
Cabinet front rail
Airflow
‘Y’
Hob
Induction hobs need ventilation channels
SIDE VIEW (Timber/Laminate worktop application)
PLAN VIEW (Granite worktop application)
800mm, 1000mm Double Drawerline Cabinets
Gas Hobs
Induction Hobs Ventilation
Induction Hob & Granite / Solid Surface
250mm 250mm
CN818061
Prepare cabinet and plate(s) Remove plate(s) Fit worktop and hob Fit plate(s)
Underside of the worktop
Routered sections (max 250mm)
Hob Cut-out
‘Y’ ‘Y’
Hob Cut-out
700mm, 800mm, 900mm, 1000mm High Line Cabinets
Notch out the plate around the centre rail. Two additional brackets are required to fix the plates in place.
Z = 463mm
22
2
2 2
2
1
1 1
1 1
/