Hob Separator Plate
CN719010
Assembly
HTPLE01
NOTE: Ensure packaging is disposed of in a safe
environmentally friendly way
Separator plate may not allow use of internal
storage drawer sets
FRONT VIEW
Fit support plate KD blocks x2.
(Plate rests upon KD blocks)
Cut front rail as
necessary for hob
Cut the 6mm board to the internal width of the cabinet
(564mm etc) and depth shown.
Fit larder brackets x3.
Underside of
the plate
455mm
425mm
When fitting a hob into a worktop a heat resistant 6mm separator plate (plywood, hard board, MDF, etc)
is required to isolate the underside of the hob (unless above an oven).
Note: The plate must allow ventilation for the hob and be easily removed for any service needs.
This assembly guide shows an example method of fitting a separator plate.
Necessary clearance from instruction booklet
C + D = Separator plate fitting depth X
X
Hob Depth
Hob Protrusion
6mm
‘C’
‘D’
‘B’
‘A’
Worktop Depth
Mark cabinet depths X and cutout section.
Fitting depth depends upon worktop thickness and hob
protrusion depth.
470mm
X
X
X
Cut out
1
2 3
7mm Max
x2
6mm
When fitting a timber or laminate
worktop, router the underside as
shown to a depth of 3mm.
5mm from
the moisture
barrier
Z = 463mm
When fitting granite worktops, the front rail of the cabinet will need to be
routered (3mm in depth) at set intervals to allow for airflow (as above
timber / laminate worktop method is not possible).
Note: Do not router the full length of the front rail, as this is required as
support for the granite worktop.
Depending upon application a granite support bar may need to be
fitted if front rail is reduced in size (and strength) significantly.
Routered sections
After fitting the worktop and hob secure
separator plate using x3 larder brackets.
Cut out as necessary for gas pipe connection etc.
35mm
Cabinet front rail
Airflow
‘Y’
Hob
Induction hobs need ventilation channels
SIDE VIEW (Timber/Laminate worktop application)
PLAN VIEW (Granite worktop application)
For 1000mm base cabinet x2 smaller plates needed.
Gas Hobs
Induction Hobs Ventilation
Induction Hob & Granite / Solid Surface
250mm 250mm
CN719010
Prepare cabinet and plate(s) Remove plate(s) Fit worktop and hob Fit plate(s)
Underside of the worktop
Routered sections (max 250mm)
Hob Cut-out
‘Y’ ‘Y’
4
Z Z
Hob Cut-out
1
2
3
-
1
-
2
LAMONA LAM1551 Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Essentials ESSEH60RC Users Manual & Installation Handbook
-
New World NWSHU601 Datasheet
-
-
Belling IH60RXL Datasheet
-
-
Belling IH6013 Owner's manual
-
-
Miele CS1312 User manual
-
-