© 2007 SCOSCHE INDUSTRIES, INC.
SI 1/02 - TA1467 (3000364)
If you have any further questions call: TECH HELP, 1-800-621-3695x3
TA1467
IN-DASH INSTALLATION KIT FOR
2002-UP TOYOTA CAMRY VEHICLES
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash
disassembly, wire harness/codes and information pertaining to installation of this kit (TA1467) in
2002-UP Toyota Camry Vehicles. Scosche Industries, Inc. can not be held responsible for
discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or
options, or damage that may occur in the automobile during the installation of components while
using this booklet.
For Factory Wiring Codes go to: www.scosche-cars.com
FACTORY WIRING CODES
TA1467 MOUNTING TRIM
TN2150 SERIES POCKET
LEFT TOYOTA
BRACKET #2442L
TOYOTA TRIM #2699
2
Thank you for purchasing the Scosche TA1467 Kit. This kit was manufactured with the highest of quality
standards.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLA-
TION TO HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/
OHM METER OVER A TEST LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE
PROBE CAN CAUSE DAMAGE TO THE VEHICLE'S COMPUTER AND/OR DIAGNOSTIC
SYSTEMS. AVOID ALL FACTORY AIR BAG WIRING - AIR BAGS CAN ACCIDENTALLY DEPLOY
CAUSING SERIOUS INJURY OR DEATH.
NOTES:
• See your vehicle's instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
INTRODUCTION / PRELIMINARY
TN2150 POCKET
POCKET ASSEMBLY
ATTACHING THE TRIM RING:
Press the pocket into place on the back of
the trim ring and use the screws to secure,
see Illustration.
TOYOTA TRIM 2699
ATTACHING THE BRACKETS:
Insert the left bracket with the
corresponding locators on the left side
of the pocket and do the same with the
right bracket (see Illustration).
LEFT TOYOTA
BRACKET 2442L
RIGHT TOYOTA
BRACKET 2442R
TN2150 POCKET
3
STEREO INSTALLATION
MOUNTING THE RADIO:
1. Mount the aftermarket radio and pocket to the factory metal
mounting brackets using the factory hardware (see
Illustration).
2. Secure the radio mounting assembly to the dash using
screws used to secure the factory radio.
FACTORY
METAL
MOUNTING
BRACKET
REAR
SUPPORT
ISO MOUNT RADIO
TA1467 TRIM
FACTORY
METAL
MOUNTING
BRACKET
RADIO REMOVAL:
1. Carefully pry out climate controls using panel removal tool. Disconnect and remove.
2. Carefully pull radio bezel.
3. Extract (4) 10mm bolts securing radio bracket, disconnect and remove radio..
POCKET ASSEMBLY
CAUTION:
REAR SUPPORT AVAILABLE
SEPARATELY. REAR SUPPORTING
THE RADIO ADDS TO THE
INSTALLATIONS STRUCTURAL
INTEGRITY.
4
DOUBLE DIN INSTALLATION
MOUNTING THE RADIO:
1. Mount the aftermarket radios to the factory metal mounting
brackets using the factory hardware (see Illustration).
2. Secure the radio mounting assembly to the dash using
screws used to secure the factory radio.
CAUTION:
REAR SUPPORT AVAILABLE
SEPARATELY. REAR SUPPORTING
THE RADIO ADDS TO THE
INSTALLATIONS STRUCTURAL
INTEGRITY.
FACTORY
METAL
MOUNTING
BRACKET
REAR
SUPPORT
TA1467 TRIM
FACTORY
METAL
MOUNTING
BRACKET
RADIO REMOVAL:
1. Carefully pry out climate controls using panel removal tool. Disconnect and remove.
2. Carefully pull radio bezel.
3. Extract (4) 10mm bolts securing radio bracket, disconnect and remove radio..
DOUBLE DIN RADIO
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Scosche KA2068B User manual
-
Scosche HA1572B User manual
-
Scosche TA2074B User manual
-
Scosche VO4148B User manual
-
Scosche NN1641B Datasheet
-
-
-
Scosche TA2043B User manual
-
Scosche TA2044B User manual
-
Other documents
-
Metra 88-00-8000 Operating instructions
-
PAC TTR992 User manual
-
-
-
-
-
-
Metra Electronics 99-8218 User manual
-
-
Metra Electronics 99-8100 User manual
