2002-UP HONDA CIVIC SI KIT
© 2003 SCOSCHE INDUSTRIES, INC.
SI 10/03 - HA1572 (3000003)
If you have any further questions, call our toll free technical help line at: 1-800-621-3695x3
HA1572
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash
disassembly, wire harness/codes and information pertaining to installation of this kit (HA1572) in 2002-
UP Honda Vehicles. Scosche Industries, Inc. can not be held responsible for discrepancies/inconsisten-
cies that may occur due to the automobile manufacturing changes or options, or damage that may
occur in the automobile during the installation of components while using this booklet.
For Factory Wiring Codes go to: www.scosche-cars.com or Call
FACTORY WIRING CODES
INTRODUCTION / PRELIMINARY
STEREO INSTALLATION
Thank you for purchasing the Scosche HA1572 Kit. This Kit was manufactured with
the highest of quality standards.
NOTES:
See your vehicle’s instructions for any special tool your installation might require.
Read all instructions accompanying your car stereo for proper wiring and mounting
instructions.
1. Remove shift knob and unsnap shift lever trim panel.
2. Remove two lower bolts securing center trim panel
3. Unsnap and remove the dash trim panel and disconnect wiring to it.
4. Remove (3) Phillips head screws securing climate control pod to back of
dash trim panel.
5. Remove climate control pod.
6. Remove (4) screws from each side of radio and remove unit.
2002-UP HONDA CIVIC SI KIT
© 2003 SCOSCHE INDUSTRIES, INC.
SI 10/03 - HA1572 (3000003)
If you have any further questions, call our toll free technical help line at: 1-800-621-3695x3
HA1572
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash
disassembly, wire harness/codes and information pertaining to installation of this kit (HA1572) in 2002-
UP Honda Vehicles. Scosche Industries, Inc. can not be held responsible for discrepancies/inconsisten-
cies that may occur due to the automobile manufacturing changes or options, or damage that may
occur in the automobile during the installation of components while using this booklet.
For Factory Wiring Codes go to: www.scosche-cars.com or Call
FACTORY WIRING CODES
INTRODUCTION / PRELIMINARY
STEREO INSTALLATION
Thank you for purchasing the Scosche HA1572 Kit. This Kit was manufactured with
the highest of quality standards.
NOTES:
See your vehicle’s instructions for any special tool your installation might require.
Read all instructions accompanying your car stereo for proper wiring and mounting
instructions.
1. Remove shift knob and unsnap shift lever trim panel.
2. Remove two lower bolts securing center trim panel.
3. Unsnap and remove the dash trim panel and disconnect wiring to it.
4. Remove (3) Phillips head screws securing climate control pod to back of
dash trim panel.
5. Remove climate control pod.
6. Remove (4) screws from each side of radio and remove unit.
1
