Click BOOSTER PACK is the
add-on board for LaunchPad®
from Texas Instruments® .
It features mikroBUS™ host
socket, allowing developers to
use dozens of click™ add-on
boards from mikroElektronika.
mikroBUS™ host connector consists of two 1x8
female headers containing pins to be most likely
used in the target add-on board. There are three
groups of communication pins: SPI, UART and I2C.
There are also single pins for PWM, Interrupt,
Analog input, Reset and Chip Select. Pinout contains
two power groups: +5V and GND on one header and
+3.3V and GND on the other 1x8 header.
mikroBUS™ host connector perfectly fits into
standard breadboards.
www.mikroe.com
for more information, please visit
What is mikroBUS™?
Click™ boards are popular add-on boards in mikroBUS™
form factor. Each one carries a specific functionality,
whether it is a communication layer, sensor, analog
input, storage module, etc. Click™ boards are compact
in size and are easily integrated into target devices,
making them a great choice for fast prototyping.
Each comes with user manual and a set of examples.
What are click™ boards?
AN - Analog pin
RST - Reset pin
CS - SPI Chip Select line
SCK - SPI Clock line
MISO - SPI Slave Output line
MOSI - SPI Slave Input line
+3.3V - VCC-3.3V Power line
GND - Reference Ground
PWM - PWM output line
INT - Hardware Interrupt line
RX - UART Receive line
TX - UART Transmit line
SCL - I2C Clock line
SDA - I2C Data line
+5V - VCC-5V Power line
GND - Reference Ground
Downloaded from Arrow.com.
