2. Minka Group
  3. P5770-084

Minka Group P5770-084, P5770-695 User manual

  • Hello, I have reviewed the installation instructions for the Minka Group light fixture model P5770-695#084. This document provides step-by-step instructions on how to mount the fixture, connect the wires, and complete the installation. It also includes important safety information and details about the required bulb type and wattage. I'm ready to answer any questions you have about this document or the installation process.
  • What is the maximum wattage of the bulb for this fixture?
    Who should install this fixture?
    What should I do before starting the installation process?
INSTALLATION INSTRUCTIONS
For Models # P5770-695#084
WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
(11/25/2013)
F i g. 1
Fig. 2
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off power at the circuit breaker and
remove the old fixture including the mounting
hardware.
2. Carefully remove the fixture from the carton
and check that all parts are included as
shown in the illustration.
3. Remove cap nut (F) from lamp body (E).
Secure crossbar (A) using mounting screws
(B) to the outlet box (not included). The length
of all thread into crossbar (A) may be
adjusted if necessary. Make sure the side of
the crossbar (A) marked “GND” must face
out.
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig.
2, making sure that all wire connectors (C)
are secured. If your outlet has a ground wire
(green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the crossbar
(A) using the green screw provided.
FINISHING THE INSTALLATION (Fig. 1)
5. Install (1) one medium base bulb (D) up to 60
watts each or CFL or LED equivalent (not
included) in accordance with the fixture
specification—DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!).
6. Align lamp body (E) onto crossbar (A) and
secure with cap nut (F).
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
Your installation is now complete. Return
power to the junction box and test the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set#A-010
- Crossbar
- Green Screw
- Mounting Screw*2
/