Digital Monitoring Products 1148 Installation Guide
2
Programming the Transmitter in the Panel
Program the device as an Emergency Zone in Zone Information during panel programming.
At the Serial Number: option, enter the eight-digit serial number. Refer to the panel
programming guide as necessary.
LED Status Operation Programming
:KHQWKHEXWWRQLVSUHVVHGWKH6WDWXV/('RSHUDWHVDFFRUGLQJWRWKH/('23(5$7,2112<(6RSWLRQLQ
=21(,1)250$7,21
YES7KH6WDWXV/('EOLQNVRQFHZKHQWKHEXWWRQLVSUHVVHGDQGWKHQRQFHHYHU\VHFRQGIRUÀYHPLQXWHVWR
FRQÀUPDPHVVDJHZDVVHQW
NO7KH6WDWXV/('EOLQNVRQFHZKHQWKHEXWWRQLVSUHVVHGWRFRQÀUPDPHVVDJH
was sent.
When Supervision time is set to 0, the 1148 Status LED blinks once every minute to
FRQÀUPFRPPXQLFDWLRQIURPWKHSDQHO:KHQ6XSHUYLVLRQWLPHVHWWRRUWKH
Status LED only blinks when the button is pressed. See Figure 5.
:KHQXVLQJ6XSHUYLVRU\WLPHRIRUUHPRYLQJWKHSHQGDQWIURPWKHSDQHO
location for greater than the Supervisory time will result in a Zone missing display at
the keypad.
Note: When a receiver is installed, powered up, or the panel is reset, the supervision
time for transmitters is reset. If the receiver has been powered down for more than one hour, wireless transmitters
may take up to an additional hour to send a supervision message unless tripped, tampered, or powered up. This
RSHUDWLRQH[WHQGVEDWWHU\OLIHIRUWUDQVPLWWHUV$PLVVLQJPHVVDJHPD\GLVSOD\RQWKHNH\SDGXQWLOWKHWUDQVPLWWHU
sends a supervision message.
LED Survey
7KH(PHUJHQF\3HQGDQWSURYLGHVDVXUYH\FDSDELOLW\ZKHQ/('2SHUDWLRQRSWLRQLVVHWWR12WRDOORZRQH
SHUVRQWRFRQÀUPWUDQVPLWWHUFRPPXQLFDWLRQZLWKWKHUHFHLYHU7KH6WDWXV/('WXUQVRQZKHQHYHUGDWDLVVHQW
to the receiver then immediately turns off when the receiver acknowledgement is received.
3UHVVLQJWKHEXWWRQVHQGVGDWDWRWKHUHFHLYHUWRFRQÀUPRSHUDWLRQ:KHQWKHWUDQVPLWWHUGRHVQRWUHFHLYH
DQDFNQRZOHGJHPHQWIURPWKHUHFHLYHUWKH/('UHPDLQVRQIRUDSSUR[LPDWHO\HLJKWVHFRQGVWRLQGLFDWHWKDW
FRPPXQLFDWLRQLVQRWHVWDEOLVKHG&RPPXQLFDWLRQLVDOVRIDXOW\ZKHQWKH/('ÁDVKHVPXOWLSOHWLPHVLQTXLFN
succession. Relocate the Pendant or receiver until the LED immediately turns off indicating the transmitter and
UHFHLYHUDUHFRPPXQLFDWLQJSURSHUO\3URSHUFRPPXQLFDWLRQEHWZHHQWKHWUDQVPLWWHUDQGUHFHLYHULVYHULÀHGZKHQ
IRUHDFKSUHVVRIWKHEXWWRQWKH/('EOLQNVLPPHGLDWHO\RQDQGLPPHGLDWHO\RII5HSHDWWKLVWHVWWRFRQÀUPÀYH
separate consecutive LED blinks. Any indication otherwise means proper communication has not been established.
Figure 5: Status LED
LED