SportsArt Fitness T672 Owner's manual

2012.09

Installation and Operation

Note: iPod is a trademark of Apple Inc., registered in the US and other countries.

"Made for iPod" means that an electronic accessory has been designed to connect specifically to

iPod and has been certified by the developer to meet Apple performance standards. Apple is not

responsible for the operation of this device or its compliance with safety and regulatory standards.

For the T672 Treadmill

CardioActive™ Entertainment Station

– Integrated TV

TABLE OF CONTENTS

CARDIO ACTIVE ENTERTAINMENT STATION (INTEGRATED TV)

FOR THE T672 TREADMILL

CARDIO ACTIVE ENTERTAINMENT STATION (INTEGRATED

ANALOG TV) OPERATING MANUAL

CARDIO ACTIVE ENTERTAINMENT STATION – INTEGRATED

DIGITAL TV

CHAPTER 1:

CHAPTER 2:

CHAPTER 3:

1.1 ................................................................................................

1.2 ..................................................................................................

1.3

2.1 TV Operating Instructions...................................................................................

2.2 CATV Function Settings......................................................................................

2.3 OSD Menu and Keys in CATV Mode..................................................................

2.4 How to Perform the Search Function..................................................................

2.4.1 Search Function Illustrations - TV System........................................................

2.4.2 NTSC Cable Illustration.....................................................................................

2.4.3 TV Scan.............................................................................................................

2.4.4 TV Channel Search in Progress........................................................................

2.4.5 iPod Function....................................................................................................

2.5.1 iPod Function Illustrations – iPod System.........................................................

2.5.2 iPod Function Illustrations – iPod ON................................................................

2.5.3 iPod Function Illustrations – Source Key...........................................................

2.6.1 OSD Menu, Other Functions - Video................................................................

2.6.2 OSD Menu, Other Functions - Audio.................................................................

2.6.3 OSD Menu, Other Functions - System..............................................................

2.6.4 OSD Menu, Other Functions - DTV...................................................................

3.1 Digital TV System Cable Connections.................................................................

3.2 Integrated TV Screen Illustration..........................................................................

3.3 DTV ATSC-USA Digital TV Functions.............................................................（）

INTRODUCTION

LIST OF PARTS

INSTALLATION INSTRUCTIONS.......................................................................

1

2

3

20

21

24

25

26

27

28

29

30

32

34

35

3.4 DTV Mode Operation...........................................................................................

3.4.1 DTV Mode.........................................................................................................

3.4.2 ATSC Menu.......................................................................................................

3.4.3 DTV Mode Key Definitions................................................................................

3.5 Introduction to the ATSC Menu............................................................................

3.6 Auto Search Operation.........................................................................................

3.6.1 DTV Menu.........................................................................................................

3.6.2 Scan Window....................................................................................................

3.6.3 Channel Search Completed Window.................................................................

3.6.4 Channel Scan....................................................................................................

3.7 ........................................................

3.8 The System Setup Process..................................................................................

3.8.1 Country Setting.................................................................................................

3.8.2 Channel Search................................................................................................

3.8.3 Channel Search Block Diagram.........................................................................

3.9 Other Notes..........................................................................................................

3.9.1 DVB-TSD Menu.................................................................................................

3.9.2 Program Search................................................................................................

3.9.3 Parental Control................................................................................................

3.9.4 System Settings................................................................................................

3.9.5 Games...............................................................................................................

3.9.6 Accessories.......................................................................................................

3.9.7 Personal Style...................................................................................................

3.10 Setup Menu Navigation......................................................................................

4.1 Channel Scan......................................................................................................

4.1.2 Display Function Settings.................................................................................

4.1.2 Other Functions................................................................................................

4.1.3 Setup Wizard Troubleshooting.........................................................................

4.1.4 Country/Language Setting................................................................................

4.1.5 Main System Screen Troubleshooting..............................................................

CHAPTER 4: DTV DVB-T HD(European High Resolution) Digital TV Functions

DVB-T SD (European) Digital TV Functions

3.11 DVB TSD Frequency Table and Country List.....................................................-

37

38

39

41

42

44

48

51

.52

52

53

54

55

56

60

63

65

66

68

1

CHAPTER 1－CARDIO ACTIVE ENTERTAINMENT STATION

(INTEGRATED TV) FOR THE T672 TREADMILL

1.1 INTRODUCTION

Congratulations on the purchase of a high quality SportsArt accessory the CardioActive

Entertainment Station for the T672 treadmill The CardioActive Entertainment Station is

an integrated TV station for use on several SportsArt products Constructed of high

quality materials and designed for years of reliable performance this accessory was

made for full commercial use

Before this product is assembled or operated we recommend that you familiarize

yourself with this manual Understanding the correct assembly and operation of this

product will help ensure that you get optimum results

Please note that SportsArt products use two types of boards for iPod devices One board

only has audio functions The other board has audio and video functions Only the audio

video board is suitable for use with the integrated TV module Do not use the audio only

board with the integrated TV module

Note iPod is a trademark of Apple Inc registered in the US and other countries

Made for iPod means that an electronic accessory has been designed to connect

specifi cally to iPod and has been certifi ed by the developer to meet Apple performance

standards Apple is not responsible for the operation of this device or its compliance with

safety and regulatory standards

,

.

,

.

,

.

..-

.-

.

:., .

""

.

™

2

1.2 LIST OF PARTS

Screwdriver bit and geeen handle

1

Flat and Phillips

No Name Qty Specifi cation Notes..

3

1.3 INSTALLATION INSTRUCTIONS

Follow instructions below to assemble this product. Note that in this manual the words

“left” and “right” are used to refer to the product and its parts. As such, these

designations correspond to the “left” and “right” sides of a person in position to exercise

on this product. Also, for brevity, the word “screws” is used where screws, washers, and

other hardware may be involved.

The illustration below shows the integrated TV screen installed on a T672 treadmill.

It shows the end result of this assembly process.

4

To access the motor compartment, remove covers as explained in steps (a)

through (b) below.

(a) Remove screws from the power cord connector, and unplug the cord.

(b) Remove the motor left and right covers, top and front covers in the order

shown below (a), (b), (c),and (d).

STEP 1 Remove Covers

(b)

(a)

c

b

a

5

Install the adapter and its cord as explained in instructions (a) through (f) below.

(a) Use the single hole to secure the set strap onto the inside of the front motor cover as

shown.

(b) Remove the backing from one side of the double-sided foam tape. Use the tape to

secure the adapter box (A4) to the inside of the front cover between the two screw

holes.

Select a suitable hole in the set strap (A8) and use a screw to secure the adapter

(A4) into place.

(d) Cut off and dispose the unused part of the set strap (A8).

(c)

STEP 2 Install the Adapter

(b)

(a)

(d)

(c)

6

STEP 2 Install the Adapter (Continued)

(e) Squeeze the sides of the power switch and pull it toward yourself. Disconnect cable

connections from the filter and the power switch. Connect cable (A5). Then insert

the power switch back into place as shown. (Be careful to ensure that L and N wires

are in the correct position.)

(e)

7

STEP 2 Install the Adapter (Continued)

(f)

(f) Secure the ground wire from cable (A5) and the ground wire from the pedestal as

shown.

8

Follow instructions (a) through (e) to install cables into the pedestal.

(a) First, remove the left bottle holder.

(b) Insert the end of the cable (A3) with the plastic cover into the hole under the bottle

holder. Feed the cable through the pedestal as shown. At the bottom of the

pedestal, remove the plastic cover after pulling the cable through the hole in the

pedestal mount. At the top of the pedestal, insert the cable up to the line on the

cable.

STEP 3 Install Cables

(a)

(b)

9

STEP 3 Install Cables (Continued)

(c) First, remove the terminal bracket and install the appropriate bracket cover plate

(A6). Connect cable (A3a) to the cover plate (A6). Then secure the terminal bracket

onto the unit as shown.

(d) Connect cable (A3b) to the adapter (A4). (Note: After connecting cable (A3b) to the

adapter (A4), push the plastic sheath into place to cover the connectors. To the

other end of the adapter (A4) connect cable (A5).

(e) Secure left and right side motor covers, the upper cover, and the front cover in order

(a)(b)(c)(d). (Note: Before securing the front cover, gather cables into the interior as

much as possible.

(d)

(c)

10

STEP 3 Install Cables (Continued)

(e) Secure left and right side motor covers, the upper cover, and the front cover in order

(a)(b)(c)(d). (Note: Before securing the front cover, gather cables into the interior as

much aspossible.)

(e)

b

c

a

c

11

Remove the cutaway in the display lower cover as follows.

(a) Remove screws from the display lower cover.

(b) Remove the sticker from the lower cover. Then use wire cutters to remove the

cutaway in area A of the lower cover.

STEP 4 Remove the Cutaway

12

Follow instructions (a) through (b) to remove the display upper cover.

(a) Open the display upper cover slowly to avoid detaching cables. Disconnect the

USB cable. Place the display upper cover flat on the handles.

(b) Detach the feeder wire from the left side of the handle. Wrap the feeder wire around

the upper part of cable (A3). Then use the feeder wire to pull cable (A3) to the front

of the display set plate

STEP 5 Remove the Display Upper Cover

(b)

(a)

13

Follow instructions (a) through (e) to install the integrated T module.

(a) uide the integrated T module into the hole in the lower cover. (ote While inserting

the integrated T module into place feed the cables through the hole in the center of

the display lower cover.)

(b) Secure screws () first in area A then in area B. After securing the integrated T

module carefully cut the ip tie off the cables.

STEP 6 Install the Integrated TV Module

(b)

(a)

A

B

14

STEP 6 Install the Integrated TV Module (Continued)

(c) First, connect cable (L1) to cable (A3). Then detach the coaxial cable splitter (A7)

from the metal plate. Connect CATV and DTV cables to the splitter (A7) as shown.

Secure the splitter (A7) onto the display set plate. Then secure the ground wire from

cable (L2) onto the splitter (A7) as shown.

(c)

15

STEP 6 Install the Integrated TV Module (Continued)

(d) Connect the integrated TV cable (L2) to the decoder board for iPod. (Note: Not

every decoder board for iPod supports audio-video functions. With the integrated

TV module, only use the audio-video decoder board. If not using iPod functions,

do not connect cable L2.)

(e) Connect the integrated TV cable (L3) to the display circuit board as shown.

(e)

(d)

a

b

16

STEP 7 Secure the Display Upper Cover

Follow instructions (a) through (c) to secure the display upper cover.

(a) Connect the USB cable into place. Organize other cables into place to avoid

pinching them. Close the display upper cover.

(b) Install the left bottle holder into place.

(c) Secure the display upper cover into place.

(c)

(b)

(a)

17

To secure the angle of the TV at its recommended position, follow instructions on the

sticker (inside the neck cover). To secure the TV screen angle at a different position,

follow steps (a) through (d) below.

(a) Remove the integrated TV module neck cover.

(b) Remove the screws at the lower left and right sides of the bracket. Loosen (but do

not remove) screws in position (A) until the angle of the TV screen can be adjusted.

(c) After adjusting the angle of the integrated TV screen, secure screws in area (A).

While aligning screw holes, secure other screws that were removed in step (b).

(d) Fit the integrated TV module neck cover to mesh inside the display top cover in area

(B). Then secure the integrated TV module neck cover with its screws.

STEP 8 Adjust the TV Screen Angle

(c)

B

(a)

(d)

A

(b)

A

Page is loading ...

SportsArt Fitness T672 Owner's manual

This manual is also suitable for

SportsArt Fitness T672 Owner's manual

Related papers

Other documents