Kreg Jig Drill Guide Block User manual

Brand
Kreg
Model
Jig Drill Guide Block
Type
User manual
NK7533
Version 2 - 06/2018
NK7533
Version 2 - 05/2018
www.kregtool.com 800.447.8638
www.kregtool.com 800.447.8638
KREG TOOL COMPANY
201 Campus Drive
Huxley, Iowa 50124
KREG TOOL COMPANY
201 Campus Drive
Huxley, Iowa 50124
Drill Guide Block
Drill Guide Block
Item# K3DGB
Item# K3DGB
The Kreg
®
Drill Guide Block is designed for use with
the Kreg Jig
®
K4, K4MS, K5, and K5MS benchtop
bases and the Kreg Jig
®
Portable Base.
The Kreg
®
Drill Guide Block is designed for use with
the Kreg Jig
®
K4, K4MS, K5, and K5MS benchtop
bases and the Kreg Jig
®
Portable Base.
Drill-Guide block positioned for
3
⁄4" thick material.
Drill-Guide block positioned for
3
⁄4" thick material.
ADJUSTING THE DRILL GUIDE
For a strong joint, the screw should exit close to
the center of the workpiece thickness. To adjust
the pocket-hole position, disengage the drill-guide
locking pin on the benchtop or portable base.
Then raise or lower the drill guide until the mark on
the side of the guide that matches the thickness
of the workpiece is even with the top of the guide
socket. Re-engage the locking pin.
ADJUSTING THE DRILL GUIDE
For a strong joint, the screw should exit close to
the center of the workpiece thickness. To adjust
the pocket-hole position, disengage the drill-guide
locking pin on the benchtop or portable base.
Then raise or lower the drill guide until the mark on
the side of the guide that matches the thickness
of the workpiece is even with the top of the guide
socket. Re-engage the locking pin.
USING THE DRILL GUIDE
BLOCK SEPARATELY
In situations where clamping the drill guide block in
place is not possible, you may screw the drill guide
directly to the workpiece with two Kreg SML screws.
USING THE DRILL GUIDE
BLOCK SEPARATELY
In situations where clamping the drill guide block in
place is not possible, you may screw the drill guide
directly to the workpiece with two Kreg SML screws.
PORTABLE BASE
PORTABLE BASE
BENCHTOP BASE
BENCHTOP BASE
LOCKING PIN
LOCKING PIN
CENTER
GUIDE
CENTER
GUIDE
ATTENTION:
!
With the drill guide block screwed
to the workpiece, use the center drill guide.
ATTENTION:
!
With the drill guide block screwed
to the workpiece, use the center drill guide.
WARNING:
!
This product can expose you to
chemicals including Carbon 1333-86-4, which are known to
the State of California to cause cancer. For more information
go to www.P65Warnings.ca.gov.
WARNING:
!
This product can expose you to
chemicals including Carbon 1333-86-4, which are known to
the State of California to cause cancer. For more information
go to www.P65Warnings.ca.gov.
  • Page 1 1

Kreg Jig Drill Guide Block User manual

Brand
Kreg
Model
Jig Drill Guide Block
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents