Nightstand with Drawer
USER’S MANUAL
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
03
Before You Start
02
Read each step carefully before starting. It is very important
to ensure each step followed in correct order, otherwise
assembly difficulties may occur.
Most of board parts are labeled or stamped on the raw
edges. Have a check to make sure all parts are included.
Work in a spacious area, preferably on a carpet close to
where the unit will be used.
Keep the handtools close at hand. Do not use power tools to
assemble your furniture. They may scratch or damage the
parts.
No. Part Qty
ATop 1
BBottom 1
CSide panel 2
2
D 1
1
1
E
F
G 1
H
1I
Minifix
1
5
8
2
9
3
6
4
7
Wood dowel
M8 x 30mm
CSK Screw
M4 x 32 mm
CSK Screw
M3.5 x 16mm Handle
Handle screw
M4 x 18mm Power nail 3/4PVC nail leg
Drawer slide
J 1
1K
12 sets
X4
X12 1 set
X8 X10
X25
X1
X2
Apron top
Apron bottom
Back panel
Drawer face
Drawer side panel
Drawer back
Drawer front
Drawer bottom
04 05
M4 x 32 mm
M4 x 18 mm
M3.5 x 16mm
1-Install the drawer front, drawer back and drawer side LR. Then
install the drawer bottom and drawer slide on side panel L/R bottom.
Then assemble the drawer handle with screws.
3
4
5
6
7
8
x2
x4
x8
x1
x2
x8
#A
8x
8
4
6
7
06 07
2- Install the wood dowel on the side panel, drawer slider LR on the
side panel, then install the titus minifix on the correct hole.
3- Install the apron bottom on the bottom panel. Then place the top
apron and bottom apron bottom panel between the side panels.
1
1
2
4
x4
x8
x10
x2
x4
M8 x 30 mm
#B
1
2
x8
x2
3
M3.5 x 16 mm
C
2
3
10x
2x
1
1
44x
E
B
2
M8 x 30 mm
Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polish is not necessary.
Should you choose to use polish, test first in an inconspicuous area.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the
finish.
Liquid spills should be removed immediately. Using a soft clean cloth, blot
the spill gently. Avoid rubbing.
Check bolts/screws periodically and tighten them if necessary.
It is best to keep your furniture in a climate-controlled environment.
Extreme temperature and humidity changes can cause fading, warping,
shrinking and splitting of wood.
It is advised to keep furniture away from direct sunlight as sun may
damage the finish.
Proper care and cleaning at home will extend the life of your purchase.
Following these important and helpful tips will enhance your furniture as it
ages.
Further advice about wood
furniture care
08 09
5- Put back the finish assembly
drawer to the cabinet.
Complete Assembly
25x
4 -Install the top apron on the top
panel, then place it on side panel.
Then intall the back panel with
power nail.
M4 x 32 mm
1
8
x4
x25
5x2
x4
9
-
1
-
2
-
3
-
4
-
5
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Costway KC53797NA User manual
-
MODWAY EEI-6281-WAL-GRY Assembly Instructions
-
MODWAY EEI-6275-WHI-NAT Assembly Instructions
-
MODWAY EEI-6284-BLK-CHA Assembly Instructions
-
Hodedah HIK65 BEECH Operating instructions
-
Hodedah HIK92 WHITE Operating instructions
-
Hodedah HIK69 WHITE User manual
-
GFW CAT33CWAL User manual
-
-
