Legrand Diplex Filter Assembly - 364218-01 Installation guide

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

Page 1 of 1

INSTRUCTION/INSTALLATION SHEET

DIPLEX FILTER ASSEMBLY

IS-0067 REV. B

1. Introduction

The On-Q/Legrand Diplex Filter Assembly, P/N 364218-01, (see Figure 1) is to be used with the On-Q Diplex

Filter Module and any On-Q Multi-Switches for distributing satellite signals and CATV signals over a single cable.

2. Description

The On-Q Diplex Filter Assembly attaches to the Satellite Receiver.

3. Installation

A. Refer to Figure 2.

1) Route RG6 cable from outlet to the “IN” fitting on the assembly.

2) Connect cable from “ANTENNA” output to satellite receiver.

3) Connect cable from “SATELLITE” output to satellite receiver.

4) Connect “out to TV” on satellite receiver to TV input.

NOTE: On-Q recommends using RG-6 quad-shield solid copper cable in lieu of copper clad steel, especially with

applications that involve distributing DC voltages. Solid copper offers less DC resistance than copper clad steel

and thus less of a voltage drop. Many manufactures of 3

party devices such as satellite receivers’ state NOT to

use copper clad steel for this reason. Use of copper clad steel could result in voltage drop significant enough to

interfere with a DC voltage dependant device’s operation. As in any RF or RF/DC application, try to avoid

excessively long runs.

Diplex Filter Assembly

Splits at Satellite Outlet

Receiver

Figure 1

Figure 2

on·Q