2. Office
  3. Office furniture
  4. Office & computer chairs
  5. Riverside Furniture
  6. 47138

Riverside Furniture 47138 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the Riverside Desk Chair 47038 / 47138. This document provides a parts list and step-by-step instructions for assembling the chair, including the base, casters, pneumatic cylinder, seat control, and seat. I'm ready to answer any questions you might have about putting it together!
  • What should I check before assembly?
    Where should I assemble the chair?
    How do I secure the pneumatic cylinder?
47038 / 47138
Round Back Upholstered Desk Chair
Clinton Hill
Home Office
Assembly Instructions
1 pc.
10 pcs.
(+10 pcs.
installed)
4 pcs.
Components and Hardware List
1 pc.
Riverside
FURNITURE
email: [email protected]
Made in Viet Nam
Page 1 of 2
5 pcs.
AB C
D E F
GH
M5/16 -18 x 1-1/2"
Allen Head Bolt
5/16" Spring
Washer
4 pcs.
5/16" Flat
Washer
4 pcs.
5mm Allen
Wrench Pneumatic Cylinder
& Cover
Casters Wood Base Cap
5 pcs. J
Seat and Back
Frame
1 pc.
Seat Control
Detail 2
I
F
K
Metal Base Frame
1 pc.
Detail 1
Wood Base Cap
Metal Base Frame
Casters
1 pc.
Wood Screw
Be sure to check all packing material carefully for small parts, which may have come loose inside the carton during
shipment. Separate, count and check all parts against the Parts List and Hardware List above.
To prevent possible scratches, assemble on a soft surface such as a blanket or carpet.
Step 1: Pivot the end of each metal strap attached on the bottom side of each Wood Base Cap (I). Place the Wood Base
Cap on top of each leg of the Metal Base Frame (G). Pivot the metal strap back across the Wood Base Cap and
reattach with the Screw and your Phillips Screwdriver. Repeat for all Wood Base Caps.
Step 2: Press the Casters (H) into the holes of the Metal Base Frame.
Step 3: Fit the bottom end of the Pneumatic Cylinder (F) into center of the Metal Base Frame as shown. Press down
firmly on the Pneumatic Cylinder to secure. Place the plastic Covers onto the cylinder.
Page 2 of 2
Made in Viet Nam
email: [email protected]
FURNITURE
Riverside Clinton Hill
Home Office
Assembly Instructions
Detail 3
D
A
B
C
Detail 4
Step 4: Attach the Seat Control (J) to the bottom of the Chair Seat & Back (K) with Flat Washers (C),
Spring Washers (B) and Allen Head Bolts (A) as shown. Tighten with the Allen Wrench.
Step 5: Fit the top of the Pneumatic Cylinder into the Seat Control. Sit on the seat to secure
assembly.
Note: To prevent possible damage to some types of flooring, never roll casters on unprotected hardwood or
vinyl flooring.
The lift mechanism is in a locked position for shipping. To unlock, pull straight out on the handle, and then
the lift cylinder can be activated by lifting the handle.
/