Sanus ELM203 User manual

Brand: Sanus

Model: ELM203

Category: Surge protectors

Type: User manual

Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 USA

Customer Service: 1-800-359-5520 • 651-484-7988 • [email protected] • www.sanus.com

are used for identification purposes and are trademarks of their respective owners.

ELM203 Surge Protector

(6901-100219 <01>)

Specifications

• 2100 joule

• EMI/RFI noise filtration

• Gold-plated coaxial input and outputs

• Combo ethernet/phone jack

• 15A/125V/60Hz

• Suppressed voltage rating: L-N 400V L-G 500V N-G 500V

Warranty

Your Sanus ELM203 has a five year product warranty

against manufacturer’s defects. If you have any

questions or experience any problems with your

Sanus Elements product, please contact Sanus

Systems Customer Service at 1-800-359-5520.

Avoid potential injuries! Do not disassemble the surge protector. Disassembling the surge

protector will void the warranty and may cause serious personal injury.

Avoid potential damage to your electrical components! Disconnect the surge protector during

lightning storms. Not for use near water or in areas with high moisture.

WARNINGS

Both the “Ground” and “Surge” LED lights

illuminate to indicate that the surge protector

is working. If either light fails to illuminate,

replace the surge protector.

Out

From wall, DSS,

cable, or other

coaxial output

To TV, VCR,

or other

coaxial input

From wall outlet or router

To phone/modem or ethernet input

6901-100219 <01>

Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively, “Milestone”), intend to make this manual accurate and complete.

However, Milestone makes no claim that the information contained herein covers all details, conditions, or variations. Nor does it provide for every possible

contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or

obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone assumes

no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

To reduce the risk of electric shock, use indoors only.

Use only in dry locations.

Not for use with ground-fault circuit-interrupter receptacles or receptacles with indicator

lights or controls.

To reduce the risk of  re or electric shock, do not use this device with a receptacle in which the

slot openings do not align with the blades.

Do not install this device if there is not at least 10 meters (30 feet) or more of wire between

the electrical outlet and the electrical service panel.

CAUTIONS