Thank you for choosing our product! We strive to provide the best quality and
services for our customers. Would you kindly share your experience on Amazon if
you are satisfied? Should you have any issues, please don't hesitate to contact us.
Telephone：1-800-556-6806 Mon-Fri 10am - 6pm (PST) (USA) (CAN)
Email：[email protected] (US/CA/DE/UK/FR/IT/ES/AU)
PSSS6
V1.0
SPEAKER FLOOR STAND
•Check package contents against Supplied Parts and Hardware List to assure that all compo-
nents were received undamaged. Do not use damaged or defective parts. lf you require replac-
ement parts, contact customer service at [email protected].
•Not all parts and hardware included will be used.
•Carefully read all instructions before attempting installation. If you do not understand the inst-
ructions or have any concerns or questions, please contact customer service at
•This product may contain moving parts. Use with caution.
•Do not use this product for any purpose or in any configuration not explicitly specified in this
instruction. We hereby disclaims any liability for injury or damage arising from incorrect asse-
mbly or incorrect use of this product.
•Please check www.perlesmith.com for more products and company information.
SUPPLIED PARTS
HARDWARE
1
Steel Washer Nut M8 Rubber PadWrench
B C FA
X 2 X 2 X 1 X 8X 2
G
Plastic Washer
Base X 2
01
Thread Rod X 4
04A
04B
Plastic Cover
X2
05
Hexagon Post X 2
Connector X 2
06
Post X 4
02
Top Plate X 2
03
Rubber Foot
E
X 8
IMPORTANT SAFETY INSTRUCTIONS
Metal Foot
D
X 8
STEP 1
2
Rotate the rubber feet to cover the metal columns of the base.
Used for marble floors or wooden floors
Screw the metal feet into the holes of the base.
Used for carpets
Attach the rubber feet or metal feet to the base
E
D
3
STEP 2
Connect the posts to the top plate
04A
04A
04B
03
03
02
06
02
Route Cable
F
Assemble the thread
rods and the hexagon
post, then connect
the assembly to the
top plate.
Assemble the posts
and the connectors
via enclosing the
thread rods.
4
STEP 3
Connect the base to the post assembly
05
03
STEP 3-2 Secure the base to the post assembly via tightening the nut.
F
C
B
A
01
01
STEP 3-1 Slide the plastic cover to the posts then connect the base to the posts.
5
STEP 4-2 Attach the rubber pads on the top plate.
STEP 4-1 Peel off the back paper of the rubber pads.
G
STEP 4
Secure speaker to stand
STEP 4-3 Secure the speaker to the stand.
STEP 5
6
Manage cables
Thank you for choosing our product! We strive to provide the best
quality and services for our customers. Would you kindly share your
experience on Amazon if you are satisfied? Should you have any
issues, please don't hesitate to contact us.
Telephone：
1-800-556-6806 Mon-Fri 10am - 6pm (PST) (USA) (CAN)
Email：
[email protected] (US/CA/DE/UK/FR/IT/ES/AU)
/
