Hagerco 30S - Square Corner - Beveled Push Plate Installation guide

30S and A30S Push Plate

Installation Instructions

I-TA01244

Rev 1, Rev Date: 01/04/21

Always visit www.hagerco.com for the latest Installation Instructions

HAGER COMPANIES 139 Victor Street, St. Louis, MO 63104 • (800) 325-9995

Page 1 of 1

1. Determine the mounting height of the push plate on the door. (According to the

International Building Code 2018 and 2010 ADA standards, push plates shall be installed

34 inches (864 mm) minimum and 48 inches (1219 mm) maximum above the finished

floor).

2. Place the push plate on the door so that the edge of plate is 1.5” [38 mm] from the

edge of the door

3. Once the push plate is on the desired position, mark the door using the push plate holes

as a template

4. Using a 7/64” drill bit (Hollow Metal Doors) or 1/16” drill bit (Solid Core Wood Doors),

drill pilot holes through the marked spots created on step 3. (Be sure not to drill all the

way through).

5. Install the push plate using the #6 x 5/8” Thread Forming Screws.

Tools Required:

7/64”

1/16”