Allied Brass 421T/36-PNI Installation guide

Type
Installation guide
18.00
Cap
Towel Bar
Backplate
Screw
0.7
Step 1:
Determine your desired location for installation and make a mark for the location . Make 2 marks where mounting screws will
be placed as shown below. Mark for location of installation.Drill hole at each end of the marks.
Drill holes in Wall for Backplate Mounting
Attach Towel Bar to Backplate
Step 2:
Unscrew Cap.Then mount Backplate to desired location and screw them in placed.Then insert Towel Bar into Backplate and
screw Cap.
421T
INSTALLATION INSTRUCTIONS
No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.
  • Page 1 1

Allied Brass 421T/36-PNI Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI