2. Hukoro
  3. F50344-QC

Hukoro F50344-QC User manual

  • Hello! I'm a chat assistant and I've reviewed the assembly instructions for a light fixture. This document provides clear steps on how to safely install the fixture, including wiring and mounting to a junction box. I'm ready to answer any questions you have about the installation process.
  • What should I inspect before starting the installation?
    What should I do before starting the installation or removing an old fixture?
    How to attach the mounting unit to the junction box?
Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
CAUTION
Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
EXPLODED PARTS INSTALLATION
STEP 1
Unscrew the ball nuts from the mounting unit.
Use the mounting screws to attach the
mounting unit to the junction box.
HARDWARE INCLUDED
Fixture
Fixture
Monuting Unit
Monuting Unit
Mounting Scrwes
Mounting Scrwes
Wire Nuts
Wire Nuts
Ball Nuts
Ball Nuts
Canopy
Canopy
Chain
Chain
STEP 2
1. Choose the length of the chain you need
(Open the chain using a phillips screwdriver
(not included) and pliers (not included). )
2. Open the quick link. Then attach it to
the fixture. Close the quick link.
Make the electrical connection from the junction box to the fixture.
Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Then, connect the positive, negative and
ground wires with the supplied wire nuts. Secure with electrical tape.
ASSEMBLY INSTRUCTIONS INSTALLATION
STEP 6STEP 5
STEP 4
Install bulbs (not included)Attach the canopy to the mounting screws through screw holes
as shown, and secure it with ball nuts.
STEP 3
1. Weave the fixture wire and the fixture ground wire through
the chain and canopy.
2. Open the quick link. Then attach it to the canopy.
Close the quick link.
Smooth side of wire from
the fixture identified
with the label "L"
Ground wire from
the Fixture
Ribbed side of wire from
the fixture identified
with the label "N"
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)
/