2. Extron
  3. MGP 641 xi

Extron MGP 641 xi User manual

  • Hello! I've reviewed the Extron user manual for certified USB human interface devices compatible with the MGP 641 xi. This document details supported touch panels, USB extenders, and mice/keyboards, including specific models and firmware versions. It also covers important points about HID modules, USB extenders and power recommendations. I'm ready to answer any questions you have about the devices and their compatibility.
  • What firmware supports the listed devices?
    What should I do if my touch device doesn't work out of the box?
    Where can I find a database of HID modules?
    Are all USB extenders supported?
    Do I need to power USB hubs and extenders?
Current Firmware Revision: 2.00.0000-b073
This document provides a list of certified USB human interface devices (HID) tested
by Extron on the MGP 641 xi. Due to the numerous touch devices available, this list
does not represent all touch devices that are supported.
Updated: 9/29/2023
Extron Products Affected: MGP 641 xi
MGP 641 xi SDI
TECH NOTES
Out of the box touch device support – The MGP 641 xi firmware supports most
touch devices out of the box after the calibration process without the need to load
HID modules (touch drivers). Refer to the MGP 641 xi user manual for more
information regarding calibration.
HID module support – If the touch device you wish to use does not work out of
the box, an HID module may be loaded to the MGP 641 xi using VCS. A database of
HID modules can be found at http://www.extron.com/download/hidmodules.aspx.
Communication sheets detailing instructions and devices tested are included with
each module. Please contact your Extron representative if an HID module for your
touch device is not available.
Unsupported USB Extenders – Specific USB extenders that have integrated hubs
may not be supported. These devices may have multiple USB connections or only a
single port. The list below documents devices that have been tested and are known
to work.
Powering USB Hubs and Extenders – It is highly recommended that USB hubs
and extenders be powered directly using the manufacturer’s power solution. Failing
to directly power the connected hubs and extenders can result in unstable USB
connectivity.
Unsupported USB Mice – The MGP 641 xi natively supports most standard wired or
wireless mice but may not support mice that would require additional drivers when
connected to a PC.
KNOWN ISSUES
There are no known issues with firmware version 2.00.0000-b073.
CERTIFIED TOUCH DEVICES
The table below lists the touch panels natively supported by the MGP 641 xi. This list
does not represent all touch devices supported.
Manufacturer
Model
Firmware Tested
Remarks
Elo
ET2202L
2.00.0000-b073
Elo
ET5053L
2.00.0000-b073
Elo
ET5551L
2.00.0000-b073
Planar
EP5024K-T
2.00.0000-b073
Samsung
QB13R-T
2.00.0000-b073
Sharp
4TB70CT1U
2.00.0000-b073
TSITouch
TSI49PSUKYHVCZZ
2.00.0000-b073
TSITouch
TSI43PSWMTACCZZ
2.00.0000-b073
Uperfect
M156B03
2.00.0000-b073
CERTIFIED USB EXTENDERS
The table below lists the USB extenders certified by Extron to work with the MGP 641
xi. This list does not represent all USB extenders supported. HID modules are not
available for USB extenders.
Manufacturer
Model
Firmware Tested
Remarks
Extron
USB Extender Series
2.00.0000-b073
All models are supported
Extron
FOX USB Extenders
2.00.0000-b073
All models are supported
CERTIFIED USB MICE AND KEYBOARDS
The table below lists the USB mice and keyboards certified by Extron to work with the
MGP 641 xi. This list does not represent all USB devices supported.
Manufacturer
Model
Firmware Tested
Remarks
Dell
XN966
2.00.0000-b073
Dell
MS111
2.00.0000-b073
Kensington
M0125
2.00.0000-b073
Logitech
Wireless Desktop
LX310
2.00.0000-b073
Logitech
Unifying Receiver
2.00.0000-b073
Microsoft
Wireless Desktop
3000
2.00.0000-b073
/