The multi-branch AC line cord kit is for use with SendPro™ P Series components.
The following are the only devices allowed to be connected to the multi-branch AC line cord kit:
• SendPro™ P Series
• Display AC adapter (for 15” display only)
• Power Stacker AC adapter
Important Safety and Compliance Information for Your Mailing System
Follow the normal safety precautions for all office equipment.
• Use the power cord supplied with the system and plug it into a properly grounded wall outlet located near the
system and easily accessible. Failure to properly ground the system can result in severe personal injury and/or
fire.
• The power cord wall plug is the primary means of disconnecting the system from the AC supply.
• Do not use an adapter plug on the line cord or wall outlet.
• Do not remove the ground pin from the line cord.
• Avoid using wall outlets that are controlled by a wall switch, or shared with other equipment.
• Do not route the power cord over sharp edges or trap between furniture.
• Ensure there is no strain on the power cord where it becomes jammed between the equipment, walls or
furniture.
• Be certain the area in front of the wall receptacle into which the system is plugged is free of obstruction.
• Your MSD2 15” monitor and MSPS stacker have specific AC adapters to power them.
Do not use third-party AC adapters which may damage the monitor and the stacker.
NOTE: Always follow the specific occupational safety and health standards for your workplace.
Do not connect to other devices
For use only with
Connect+™ Series components
system
display
stacker
Use only supplied Connect+™ | SendPro™ P Series system power cord
Connect+
™
| SendPro
™
P Series Power Distribution Kit
AW22653 Rev D 02/2016
Do not connect to other devices such as laser printers.
!
No conectar a otros dispositivos tales como impresoras láser.
Para utilizar sólo con componentes de la serie Connect+
™
| SendPro
™
P.
sistema
systeem
system
systeem
système
apilador
raccoglitore
mottager
opvang
ablage
avläggare
stacker
réception
visor
display
beeldscherm
afficheur
Connect+
™
| SendPro
™
P Series Power Distribution Kit
!
Non collegare altri dispositivi come stampanti laser ecc.
Da utilizzarsi solo con componenti della Serie Connect+
™
| SendPro
™
P.
!
Må ikke koples sammen med annet utstyr som f.eks. laser printere.
Kun for bruk sammen med Connect+
™
| SendPro
™
P Serie komponenter.
!
Niet aansluiten op andere apparaten zoals laser printers.
Alleen voor gebruik met Connect+
™
| SendPro
™
P Serie componenten.
!
Keine anderen Geräte, wie z.B. Laserdrucker anschliessen.
Nur mit Komponenten der Connect+
™
| SendPro
™
P Serie verwenden.
!
Anslut inte till andra enheter som t.ex. laserskrivare.
Används enbart ihop med delar till Connect+
™
| SendPro
™
P.
!
Opret ikke forbindelse til andre enheder såsom laserprintere.
Må kun anvendes med Connect+
™
| SendPro
™
P seriens komponenter.
!
Ne pas connecter avec d’autres produits tels que des imprimantes laser.
Pour utilisation uniquement avec des éléments Connect+
™
| SendPro
™
P Series.
!
/