Aiphone IX-SDH-P Install Manual

Brand: Aiphone

Model: IX-SDH-P

Type: Install Manual

IX-SDH-P

Stainless Steel Door Housing with Built-in Card Reader

The IX-SDH-P is a stainless steel enclosure with a built-in HID

multi-Class RP10 card reader for use with the

IX-DA or IX-BA network door stations. The enclosure is made of 14 gauge stainless steel and is designed to

mount to a 1 gang box or any at surface.

-INSTRUCTIONS-

IX-SDH-P Instr.

0119

MOUNTING INSTRUCTIONS:

1. Remove gray plastic cover from door station by pulling up on the tabs on the bottom of the unit. The plastic

cover can be discarded as it is not used when mounting with the IX-SDH-P.

2. Loosen the security screw with the security driver supplied with the door station.

3. Remove the door station from back frame.

4. Remove wire knock-out from bottom of back frame.

5. Align the door station back frame with the upper position of the IX-SDH-P mounting bracket. Secure both

to a single gang box and the wall with the gang box aligned with the lower position of the mounting bracket.

6. Route the door station wires through wire knock-out and connect to the station, then mount station to the

back frame with the supplied security screw.

7. Peel adhesive strips from the wire mesh and secure it over the speaker grill.

8. Route and connect the wires for card reader and attach the stainless steel cover with the supplied tamper

proof screws.

Aiphone Corporation

www.aiphone.com

[email protected]

(800) 692-0200

Wall

3-5/16"

IX-SDH-P mounting bracket

Back frame

IX-DA / IX-BA

Security screw

wire mesh

Tamper proof

screws (2)

IX-SDH-P

cover

Gray front cover

(remove and discard)

⁄

RP10 Card

Reader

1 Gang

Box

Wire knock-out

Aiphone IX-SDH-P Install Manual

Aiphone IX-SDH-P Install Manual

Aiphone IX-SDH-P Install Manual

Related papers

Other documents