Amico Majestic Series Installation guide

Type
Installation guide
Corporation
Installation Instructions
Joining Two Horizontal Headwalls
Majestic Series Horizontal Headwalls
Note
The installation instructions provided are for the Amico standard products. Slight modications
to the installations may be required. The product shipped to the job site may not be exactly as
shown on the installation drawings.
Before joining headwalls, secure headwalls to wall using separate installation instructions provided.
2 Amico Architectural
Installation
1. If in place, remove upper and lower covers of headwalls to be joined.
Remove upper cover by pushing front edge in and up around hook and pulling cover up and
away from rear extrusion lip.
Remove lower cover by removing screws which hold it in place and lowering cover away from
rear notch.
2
1
www.amico.com 3
Installation
2. Make sure gases line up on each headwall.
3. Connect electrical wiring between each headwall (wires are labelled).
4. Fasten horizontal headwall sections together using 1/4” bolts and nuts (provided) at locations
shown, while ensuring headwalls remain level.
5. Braze piping between headwalls.
attaching locations attaching locations
Single tier horizontal headwall Double tier horizontal headwall
C US LISTED
Amico Architectural | www.amico.com
85 Fulton Way, Richmond Hill
Ontario, L4B 2N4, Canada
71 East Industry Court, Deer Park
NY 11729, U.S.A
Toll Free Tel: 1.877.264.2697
Toll Free Fax: 1.866.440.4986
Tel: 905.763.7778
Fax: 905.763.8587
Email: info@amico.com
INSTALL INSTR. JOIN MAJESTIC HDWLS 2011
www.amico.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Amico Majestic Series Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI